Installation Instructions

Thank you so much choose our product .

lnstallation Method

Wall mounted installation

Put the screw through the hanging hole of the end cover (hole like key type )

2.Ceiling installation

1) Projection screen

(type A):

Install the expansion bolt on the ceiling, and let the other end of the expansion bolt

pass through the middle hole above the end cover, and lock the nut.

Projection screen (type B ): Hang the "D"-shaped lifting ring on the hook bolt installed on the ceiling

MORORIZED SCREEN

anchors

Screw

Projection screen (A)

anchors

Screw

Projection screen ( B)

Expansion bolt

Nut

Hook bolt

D-shaped

lifting ring

Projection screen (A) Projection screen (B )

RING

HOUSING

MANUAL SWITCH

BLACK BORDER

BOTTOM BAR

Motorized screen with manual switch Motorized screen with remote control

PLUG

transmitter

REMOTE CONTROL

PAGE 1
Thank you so much choose our product . lnstallation Method Wall mounted installation Put the screw through the hanging hole of the end cover (hole like key type ) anchors Screw anchors Screw Projection screen (A) Projection screen (B ) 2.Ceiling installation 1) Projection screen (type A): Install the expansion bolt on the ceiling, and let the other end of the expansion bolt pass through the middle hole above the end cover, and lock the nut.
PAGE 2
1. CIRCUIT DIAGRAMS If the motorized screen work with manual switch,please refer to the diagram below for electric connection.
PAGE 3
WALL-MOUNTED MAUAL SCREEN 1. STRUCTURE 2. INSTALLING Moving parts of the drive must be installed higher than 25 mm above the floor. Choose a suitable place for installation. It is best to install two screws on the wall, the distance of the screws must be equal to chat of the two rings and they should be at the same level. The rings must be strong enough to load more than 25kg of weight. HOUSING RING BLACK BORDER SCREEN PULLING ROD PULLING RING 3.
PAGE 4
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.