User's Manual

ManualsBrandsE-Core Technology ManualsElectronics2.4G Wireless Device

HL8860 Audi o 2. 4GHz RF

INSTRUCTION MANUAL

E-CORE TECHNOLOGY (CHINA) CO., LTD.

Federal Communications Commission (FCC) Statement

You are cautioned that changes or modifications not expressly approved

by the part responsible for compliance could void the user’s authority to

operate the equipment

FCC- Class B

This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to part 15 of the FCC Rules. These

limits are designed to provide reasonable protection against harmful

interference in a communications. However, there is no guarantee that

interference will not occur in particular installation. If this equipment

does cause harmful interference to radio or television reception, which

can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the

following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that

to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

Summary of content (5 pages)

PAGE 1
HL8860 Audi o 2. 4GHz RF INSTRUCTION MANUAL Federal Communications Commission (FCC) Statement You are cautioned that changes or modifications not expressly approved by the part responsible for compliance could void the user’s authority to operate the equipment FCC- Class B This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
PAGE 2
Thanks for select our RF 2.4G Audio controller! For play more conviently and correctly, please read the manual carefully before playing. Product Introduction Product brief Introduction HL8860 wireless Audio controller adopt 2.4GHz RF technology, with steady connection capacity, far distance, low function wastage; beautiful outlook, good handle , make you ear be personally on the scene! Technology Specification 1. Application: Wireless Home TV Headphone Wireless Portable Headphone 2. GFSK modulation 3.
PAGE 3
TX LEDand Key Function Description Connector Description Audio in Analog audio source input USB / Power in USB audio input / 5V Power source Switch Function CONNECT ID Learning Trigger POWER SW1 (Option) RF switch Audio Source Select Description When simultaneously press the buttons both on Tx and Rx system board longer than 3 seconds, the ID learning process will be enable. RF on / off switch Analog input or USB audio input Near Right is Analog input, Near Left is USB input.
PAGE 4
Use Introduction 1) RX LED and Key Function Description 2) Switch Function Description POWER RF switch RF on / off switch CONNECT Volume Volume up / down pull control ID Learning Trigger When simultaneously press the buttons both on Tx and Rx module longer than 3 seconds, the ID learning process will be enabled. LED Function Description LED3 ID / 1. When sync and audio playing LED on. Sync 2. When No Sync or No audio input or Low battery LED blinking by 1s on / 1s off. 3.
PAGE 5
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions” (1).This device may not cause harmful interference, and (2).This device must accept any interference received, including interference that may cause undesired operation. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1).This device may not cause harmful interference, and (2).