Installation Guide

ManualsBrandsDynojet ManualsPower CommanderDYNOJET V-Max 2009-2020 Power Commander

1 POWER COMMANDER 6

1 INSTALLATION GUIDE

1 USB CABLE

2 DYNOJET DECALS

2 POWER COMMANDER DECALS

2 VELCRO STRIPS

1 ALCOHOL SWAB

1 POSI-TAP

PARTS LIST

PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION.

THE IGNITION MUST BE TURNED OFF BEFORE INSTALLATION.

POWER COMMANDER 6

IPC6-22003.01

Install guide for: PC6-22003

Model coverage: 2009-2020 Yamaha V-Max

Summary of content (5 pages)

PAGE 1
POWER COMMANDER 6 Install guide for: PC6-22003 Model coverage: 2009-2020 Yamaha V-Max PARTS LIST 1 POWER COMMANDER 6 2 POWER COMMANDER DECALS 1 INSTALLATION GUIDE 2 VELCRO STRIPS 1 USB CABLE 1 ALCOHOL SWAB 2 DYNOJET DECALS 1 POSI-TAP PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION. THE IGNITION MUST BE TURNED OFF BEFORE INSTALLATION. IPC6-22003.
PAGE 2
INPUT ACCESSORY GUIDE USB CONNECTION INPUT 1 EXPANSION PORTS 1 & 2 INPUT 1 INPUT 2 INPUT 2 SPEED ANALOG OPTIONAL ACCESSORY INPUTS CRANK Map (Input 1 or 2) The PC6 has the ability to hold 2 different base maps. You can switch on the fly between these two base maps when you hook up a switch to the MAP inputs. You can use any open/close type switch. The polarity of the wires is not important. Shifter (Input 1 or 2) Used for clutch-less full throttle upshifts.
PAGE 3
INSTALLING THE POWER COMMANDER 6 1 Remove the main seat. 2 Remove the cosmetic air box cover and side panel. 3 Lay the PC6 under the right hand side cover temporarily. 4 Route the PC6 harness inside of the sub-frame and go up towards the battery. 5 Unplug the connectors from the throttle bodies. These connectors are located to the right side of the ECU. One connector is a WHITE 3-pin and the other is a CLEAR 4-pin.
PAGE 4
6 Plug the connectors from the PC6 in-line of the stock wiring harness and throttle bodies. 7 Using the supplied Positap attach the GREY wire of the PC6 harness to the stock WHITE wire of the small ECU plug. This is pin #5. 8 Attach the ground wire of the PC6 to the negative side of the battery. 9 Using the supplied Velcro, secure the PC6 to the plastic cover under the right hand side cover. Mount the PC6 behind the stock electronics.
PAGE 5
2191 MENDENHALL DRIVE, NORTH LAS VEGAS, NV 89081 - 800-992-4993 - DYNOJET.