User's Manual

ManualsBrandsDyne Telecom ManualsElectronicsUHF Wireless Remote Controller

REPORT NO : HCT-F02-1105 FCC ID :N5ZDN308R NOVEMBER 13, 2002

HYUNDAI CALIBRATION & CERTIFICATION TECHNOLOGIES CO., LTD.

SAN 136-1, AMI-RI , BUBAL-EUP, ICHEON-SI,KYOUNKI-DO, 467-701,KOREA

TEL : +82 31 639 8518 FAX : +82 31 639 8525

ATTACHMENT E.

- USER’S MANUAL

Summary of content (6 pages)

PAGE 1
REPORT NO : HCT-F02-1105 FCC ID :N5ZDN308R NOVEMBER 13, 2002 ATTACHMENT E. - USER’S MANUAL HYUNDAI CALIBRATION & CERTIFICATION TECHNOLOGIES CO., LTD.
PAGE 2
REPORT NO : HCT-F02-1105 FCC ID :N5ZDN308R NOVEMBER 13, 2002 Service Manual (DN-308R) Table of Contents The Description of Product with Remote controller 1. Description 2. Control and Function 3. Operating Instructions 4. General Specification 5. Transmitter Specifications 6. Theory of Operation m Rev 1.0 HYUNDAI CALIBRATION & CERTIFICATION TECHNOLOGIES CO., LTD.
PAGE 3
REPORT NO : HCT-F02-1105 FCC ID :N5ZDN308R NOVEMBER 13, 2002 Federal Communications Commission Requirements Warning : Changes or modifications not expressly approved by the party responsible for compliance with the FCC’S rules could void the user's authority to operate the equipment. Because of the limited space on the model DN-308R UHF Wireless Remote Controller case, the notice of compliance with FCC Rules is printed here Dyne Telecom Co.
PAGE 4
REPORT NO : HCT-F02-1105 FCC ID :N5ZDN308R NOVEMBER 13, 2002 1. Description The Remote Controller of the DN-308R is the UHF Wireless Remote Controller that can wireless trans control the Recording and Stop Functions. It is very handiness operate remote controller. 2. Control and Function - REC : Recording Start - STOP : Recording Stop 3. Operating Instructions To Record the Voice with Wireless Remote Controller : To Start the Recording : Press the “REC” key once.
PAGE 5
REPORT NO : HCT-F02-1105 FCC ID :N5ZDN308R NOVEMBER 13, 2002 5. Transmitter Specifications Output Power Frequency Band Modulation Type Frequency Deviation Maximum Bit Rate Transmitt supply Current Antenna Type Weight Max 1mW (ERP) 315.16MHz FSK ±15KHz 20Kbit/s Max 20mA 50Ω Helical ANT 15g (With Battery) 6. Theory of Operation 6-1. CPU & Key Control The unit always supply the power to the IC2(CPU).
PAGE 6
REPORT NO : HCT-F02-1105 FCC ID :N5ZDN308R NOVEMBER 13, 2002 6-4. VCO(voltage Control Oscillator) The L1, C19’s L/C OSC will activate to 300MHz Frequency by 5&6pin of IC1. The VCO will lock to Frequency 315.15MHz by IC1’s internal PLL. Upgrade the Frequency Quality by using High Frequency Inductor. 6-5. PLL Frequency Synthesizer The Phase Comparator, Lock Detector and Oscillator are built-in inside of IC1. The 1&20pin of IC1 may OSC by X-Tal Oscillator(4MHz) to active the R-Counter.