User Manual

ManualsBrandsDynaStream Innovations ManualsElectronicsSpeed and Distance Monitor

6/6/2006

SING THE

SDM2

PEED

AND

ISTANCE

ONITOR

The SDM2 Speed and Distance Monitor (foot

pod) must be attached securely on the shoe

of the user as shown. The pod must stay in

place on the shoe for optimum accuracy.

• Press the button for 1-2 seconds to

power on the pod. The red light

slowly blinks, indicating the pod is

powered on and sending data. If the

red light is solid, the pod is not

transmitting data and may require

service.

• After running, press and hold the

button to turn off the pod. The red

light becomes solid as the button is

held and then turns off as the pod

powers off.

AIRING THE

SDM2

PEED AND

ISTANCE

ONITOR

WITH A

PORTS

ONITORING

ATCH

The SDM2 Speed and Distance Monitor must “pair” with an ANT-enabled sports monitoring watch in

order to display performance data to the user. Pairing is required only for first use and after a battery

change. To pair your monitor:

• Power on the SDM2 Speed and Distance Monitor. Bring the pod within 10-30 inches (25-75 cm) of

the sports monitoring watch.

• Ensure that you are standing at least 72 inches (183 cm) away from any other ANT-enabled speed and

distance monitor. You can be in proximity to other ANT-enabled devices.

• After the SDM2 Speed and Distance Monitor pairs with the sports monitoring watch, the running

shoe icon appears on the watch’s LCD display. The pod and the watch remain paired until a battery

change.

If the watch has previously paired with a different foot pod, subsequent re-pairing is necessary. The re-

pairing procedure is similar to pairing except that the SDM2 Speed and Distance Monitor must be started

in RF Pair Mode. To power on the pod in RF Pair Mode, press and hold the button for 3-6 seconds. RF

Pair Mode lasts for 60 seconds and is indicated by a double-blinking red light.

SDM2 Wireless

Speed and

Distance Monitor

Summary of content (4 pages)

PAGE 1
SDM2 Wireless Speed and Distance Monitor USING THE SDM2 SPEED AND DISTANCE MONITOR The SDM2 Speed and Distance Monitor (foot pod) must be attached securely on the shoe of the user as shown. The pod must stay in place on the shoe for optimum accuracy. • Press the button for 1-2 seconds to power on the pod. The red light slowly blinks, indicating the pod is powered on and sending data. If the red light is solid, the pod is not transmitting data and may require service.
PAGE 2
REPLACING THE BATTERY ON YOUR SDM2 SPEED AND DISTANCE MONITOR Your SDM2 Speed and Distance Monitor uses one AAA battery, which is estimated to last 65-70 hours. Power off the pod after running to lengthen battery life. The battery hatch is located on the front flat end of the monitor and can be opened with a coin. Select a coin that fits the slot on the battery door. Insert the coin into the slot and, applying firm downward pressure, turn the coin counterclockwise to open and remove the battery door.
PAGE 3
FCC Compliance NOTE: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
PAGE 4
Warranty Information VENDOR Warranty: LIMITED WARRANTY This VENDOR product is warranted to be free from defects in materials or workmanship for one year from the date of purchase. Within this period, VENDOR will at its sole option, repair or replace any components that fail in normal use. Such repairs or replacement will be made at no charge to the customer for parts or labor, provided that the customer shall be responsible for any transportation cost.