Owner's Manual

ManualsBrandsDynaQuip Controls ManualsElectronicsSmartConnect

System Description

The WaterCop® SmartConnect is designed to work alongside the WaterCop® Pro Integrated System or WaterCop® Classic and

deliver real time notification of leaks in your plumbing system. The SmartConnect unit is powered by the Pro panel or low

voltage Classic actuators through a straight through CAT5 or CAT6 cable. The SmartConnect can be connected with up to 50ft

of straight through CAT5 or CAT6 cable can if needed to get stronger Wi-Fi reception. WCACT1, WPMS and WPMSH units will

need the external power supply (ACA100).

Check at the shipping package contains the following:

WaterCop SmartConnect device

Owner’s Manual

Read Instructions before any installation is attempted. All sections of this Product Manual and accompanying Installation Guide

should be read and completely understood.

How the System Works

The SmartConnect unit receives the valve status from the RJ45 outputs on both the Pro and Monitoring Station panel and

Classic actuator. The information goes to a cloud server and out to the SmartConnect App on your phone or tablet. The

SmartConnect App will notify when a valve changes state alerting you to a possible leak detection. The app can also notify on a

loss of signal from the SmartConnect to the cloud service which can indicate a loss of power or internet connection.

System Requirements

 Smart Phone or tablet with the following:

Android Version 5.0 or higher/ iOS - 10.3 or higher

Sim card or WI-FI connectivity

 2.4 GHz Router with Protected Wi-Fi (with a password)

 Bluetooth 4.1 or above

 50’ CAT5E cable max to WaterCop



WCACT1,WPMSandWPMSH require additional power supply (ACA100) sold separately

Summary of content (4 pages)

PAGE 1
System Description The WaterCop® SmartConnect is designed to work alongside the WaterCop® Pro Integrated System or WaterCop® Classic and deliver real time notification of leaks in your plumbing system. The SmartConnect unit is powered by the Pro panel or low voltage Classic actuators through a straight through CAT5 or CAT6 cable. The SmartConnect can be connected with up to 50ft of straight through CAT5 or CAT6 cable can if needed to get stronger Wi-Fi reception.
PAGE 2
System Set Up PREFACE: Before setup on the WaterCop SmartConnect, verify if the device will be connected to the internet via wireless or ethernet cable. If using wireless, verify signal strength before choosing the location of the SmartConnect device. When running cable from the actuator or control panel to the SmartConnect, use CAT5 or CAT6, and keep the cable 50’ or (use the supplied short cable if signal is adequate). 1) 2) 3) Setup Remove WaterCop SmartConnect from packaging.
PAGE 3
4) 5) 6) 7) Once saved and connected, cycle the valve open and closed from the app to ensure the SmartConnect is connected, operating and sending notifications. Delete your contact info by clicking the ‘ > ‘ icon on the Contacts line and then the ‘-‘ sign to the right. Click ‘yes’ when asked “Are you sure?’. Now add customer contact info and repeat this until all desired contacts are saved (only applicable if a list of contacts were provided ).
PAGE 4
Trouble Shooting Turn the device’s Bluetooth off and back on to restart the Bluetooth radio and try again Cannot see or connect to device at Add screen Remove the CAT5 cable or power supply from the SmartConnect and reconnect to cycle power No connect, buttons gray after configuring Wi‐Fi network Verify network name and password are correct, app will not notify of incorrect name or password If the issue remains contact DynaQuip Controls Valve CONNECTION LOST message While adding and setting up device,