PARALYSER 275 URIT C E Y S USER INSTRUCTIONS S Y S CYCL PS STEM Proudly designed and engineered in Australia by Dynamco Pty Ltd.
S URIT EC Y Immobiliser Vehicle Security System S Y User Instructions S CYCL PS CYCLOPS PARALYSER 275 STEM Congratulations on having one of the world's most advanced and unique Australian designed and engineered vehicle security systems, installed in your vehicle! The Cyclops Paralyser 275 has been tested to and meets Australian Standards 4601:1999.
ARMING AND DISARMING To arm or disarm the system, press the button on the remote control. Arming the system is accompanied by two flashes from the indicators and one flash for disarming (indicator connection is an optional extra). AUTO-ARMING The system is designed to automatically immobilise the vehicle. The engine will be immobilised within 40 seconds after the ignition switch has been turned off. If disarmed by remote control, the system will re-arm (immobilise) itself within the same time period.
OVERRIDE The system can be overridden by means of a Personal Identification Number (PIN). Every unit is supplied with its own PIN. It is important to make a note of this PIN or keep the card supplied with the unit in a safe p1ace as it also has the PIN detailed on it. ** Any digit marked '0', indicates 10 flashes. OVERRIDE PROCEDURE ! Insert the ignition key into the ignition switch and turn to the ON position. The red status LED mounted on the dash will glow constantly.
The remote fails to operate If the LED does not light up when a remote control button is pressed, change the battery BATTERY REPLACEMENT Using a small flat-head screwdriver, to pry apart the two halves of the remote case take care not to disturb the circuit board. Remove the old batteries whilst paying attention to the orientation of the positive and negative terminals. Insert new batteries in identical fashion to the original and re-assemble remote. Snap the case halves back together.
ANNUAL INSPECTION Dynamco prides itself on the durability and integrity of its car security systems. We welcome users to contact a Cyclops service centre every twelve months for an annual inspection.
WARRANTY Subject to the conditions stated below, to be free from manufacturing defects and faulty material within the warranty period stated below. CONDITIONS ! That the warranty registration has been completed in full at the time of purchase and / or installation and is produced when warranty service is sought.
S URIT EC S CONTROL MODULE REMOTES AFTER HOURS EMERGENCY PHONE -8- S CYCL PS Y PURCHASED FROM OWNER’S NAME TYPE OF VEHICLE VEHICLE REGO MODULE OF UNIT DATE OF INSTALL’ WARRANTY PERIOD : Y WARRANTY REGISTRATION STEM