DAM™ OWNER’S MANUAL W W W . D Y E P A I N T B A L L .
W W W . D Y E P A I N T B A L L .
W A R N I N G IMPORTANT SAFETY INSTRUCTIONS AND GUIDELINES 2 W W W . D Y E P A I N T B A L L .
W A R N I N G IMPORTANT SAFETY INSTRUCTIONS AND GUIDELINES W W W . D Y E P A I N T B A L L .
2 3 1 4 W W W . D Y E P A I N T B A L L .
4 5 6 7 W W W . D Y E P A I N T B A L L .
WARNING: AFTER STEP 5, THE DAM™ WILL BE LIVE. BEFORE PROCEEDING, MAKE SURE THE BARREL SOCK IS IN PLACE AND DO NOT POINT THE DAM™ AT ANYTHING YOU DON’T INTEND TO SHOOT. 6 W W W . D Y E P A I N T B A L L .
7
1 8 W W W . D Y E P 2 A I N T B 3 A L L .
When servicing your marker: • Make sure a barrel sock is fitted to the DAM™. • Make sure your loader/magazine is removed from the DAM™. • Make sure there are no paintballs in the breech of the DAM™. • Always remove the first stage regulator and relieve all residual gas pressure from the DAM™ before disassembly. • The DAM™ can hold a small residual charge of gas, typically 2 shots, with the first stage regulator removed. Always discharge the marker in a safe direction to relieve this residual gas pressure.
FACTORY MODE 10 W W W . D Y E P A I N T B A L L .
3 CONFIGURABLE MODE W W W . D Y E P A I N T B A L L .
12 W W W . D Y E P A I N T B A L L .
W W W . D Y E P A I N T B A L L .
2 1 • Be sure the trigger is not adjusted to the point where it is too sensitive and may cause accidental discharge of the marker. • Removing the trigger spring will cause premature wear on the microswitch, resulting in failure. 14 W W W . D Y E P A I N T B A L L .
3 W W W . D Y E P A I N T B A L L .