DLC - Ethernet MANUALE UTENTE USER'S MANUAL 06/2004
DLC-Ethernet/Rs485 DUCATI SISTEMI S.p.A. INDEX 1. Introduction.............................................................................................................1 2. Converter Description .............................................................................................2 3. 4. 5. 2.1 Ethernet connector ................................................................................................................... 3 2.2 Power supply connector...............................
DLC-Ethernet/Rs485 1. DUCATI SISTEMI S.p.A. Introduction DUCATI Sistemi s.p.a., pursuing a program of increasing participation in the energy measurements and energy saving field, has developed a data converter Ethernet - RS485 which can be used with all DUCATI analyzers provided with RS485 line interface. This converter allow connecting a single instrument or a group of instruments (all of them connected each other through the RS485 line) to an Ethernet port of a LAN, by TCP/IP protocol.
DLC-Ethernet/Rs485 2. DUCATI SISTEMI S.p.A. Converter Description The DLC-Ethernet signal converter can easily be placed and connected to any Ethernet network and used in a network for analyzers data collection (LAN cable not included).
DLC-Ethernet/Rs485 2.1 DUCATI SISTEMI S.p.A. Ethernet connector Pin2: Tx- Pin3: Rx+ Pin1: Tx+ Pin6: Rx- Figure 2: RJ45 connector– front view 2.2 Power supply connector Figure 3: PSU supply connector The positive pin (+) is connected with the internal contact, and the negative (-) is connect with the external contact.
DLC-Ethernet/Rs485 2.3 DUCATI SISTEMI S.p.A. Serial Rs485 connector 5 4 9 3 8 2 7 1 6 Figure 5: RS485 connector, DB9 – Male Noninverting Receiver Input and Noninverting Driver Output Pin 1 A (+) Pin 2 n.c. Pin 3 n.c. Pin 4 n.c. Pin 5 GND Ground Pin 6 B (-) Inverting Receiver Input and Inverting Driver Output Pin 7 n.c. Pin 8 n.c. Pin 9 n.c.
DLC-Ethernet/Rs485 3. 3.1 DUCATI SISTEMI S.p.A. Device Setup and configuration Factory default When purchased, if there aren’t any particular requests, the device will have the following default setting. Factory default Password: “ducati” (all in lower case) Username (none / blank) IP address 192.168.5.245 Subnet mask 255.255.255.0 Host port 2000 Serial Rs485 9600 bps, no parity, 1 start bit, 1 stop bit Last character 03h (etx) Figure 7: Factory default configuration table 3.
DLC-Ethernet/Rs485 DUCATI SISTEMI S.p.A. WARNING: in case the password is forgotten and the IP address is lost, the device can not be reset to the factory default configuration by the user, and should be sent back to DUCATI for service. However in order to recover the IP address it is possible to reconfigure the device with a DHCP (for more information in DHCP usage please contact our customer service at the e-mail address "supporto_analizzatori @ ducatisistemi.com".
DLC-Ethernet/Rs485 DUCATI SISTEMI S.p.A. • the WapNet Software V2.6 or above. (available from Ducati Sistemi SpA with order code 468001078)ii. For this software it is required a Personal Computer P III a 400 MHz or higher, Memory 128 Mb ram, Drive 20 GB, and Microsoft operating system. 4.
DLC-Ethernet/Rs485 DUCATI SISTEMI S.p.A. For a correct connection, follow the hints below; please note there is no limit on how many DLC-Ethernet devices can be installed on the same LAN, a part from the limit on the total device the LAN itself can handle. For more information refer to the NOTE at section 3.2 - "How to modify the configuration".
DLC-Ethernet/Rs485 DUCATI SISTEMI S.p.A. • Protection Class IP20 • Mechanical resistance EN/IEC 61131-2 • Humidity Class F DIN 40040 5.3 Weight and dimension • Module 98 x 24 x 57 mm • Weigh 67g 5.4 Connectors • Ethernet: IEEE 802.3 10BaseT RJ45 • Rs485: DB9 male (adapting cable included) • Power supply: PSU Plug 5,5 x 2,1 mm 5.
DLC-Ethernet/Rs485 DUCATI SISTEMI S.p.A. DUCATI Sistemi S. p. A. denies any responsibility for damage or personal injury caused by the improper or erroneous use of this equipment. This documentation may be subject to modification without prior notice. Documentation code: DLC_Eth_ENG_V10.doc – Version 1.0 – June 2004. Via Ronzani 47, - 40033 Casalecchio di Reno (Bologna) - Italy Tel.: +39- 051 6116.611 - Fax: +39-051 6116.690 WEB: www.ducatisistemi. com e-mail (Commerc.) = info@ducatisistemi.
