LU43PB/W - LU53PB/W INSTALLATION/OWNER’S MANUAL Indoor/Outdoor 3-Way Dynamic Loudspeakers ®
® LU43P-LU53P INTRODUCTION Introduction Introduction The DUAL outdoor speaker series is designed as a multipurpose speaker and will deliver accurate high fidelity sound in exterior or interior environments. Weather-resistant design and construction provide optimum durability for permanent or temporary outdoor use. Both models are available in black or white. For simplicity, we will call your AV receiver or amplifier the “receiver.
® LU43P-LU53P PLACEMENT Speaker Placement Mounting Placement If mounting is desired, mounting both speakers on a common solid surface facing the listening area will provide the best audio results. Do NOT mount speakers on wall surfaces that have hazards concealed behind them, such as electrical wires or plumbing. Always mount speaker on surfaces that are sturdy enough to support the speakers’ weight, and make sure they cannot fall or cause injury.
® LU43P-LU53P INSTALLATION Placement & Mounting Speakers Outdoor Placement The DUAL LU43 and LU53 have been tested for environmental usage and are weather resistant, but not waterproof. Occasional moisture will not affect performance. The speakers should be allowed to ventilate and dry after water exposure. The speakers can be placed permanently outdoors for yearround enjoyment. To maximize speaker life, position in areas protected from the elements, such as the underside of eaves and overhangs.
® LU43P-LU53P CONNECTION Connecting Speakers Connecting Your Speakers Speaker Wire -Typical speaker wire has a pair of separate speaker wires with insulating jackets that are molded together. Dual recommends the use of two conductor 18gauge speaker wire to connect your speakers to your receiver. Measure enough wire to reach from your receiver to each speaker plus additional length to allow moving the speakers or receiver without having to disconnect the wires.
® LU43P-LU53P CONNECTION & TROUBLESHOOTING Connecting Speakers Binding Post Type: LU53P STEP 1 Unscrew the caps covering each binding post until you expose the small hole through their centers. These caps are typically colored red and black, and represent positive and negative terminals, respectively. STEP 2 Twist the bare speaker wire to create a single strand. STEP 3 Insert each side into the exposed holes. STEP 4 Tighten the cap to secure the wire in place.
® LU43P-LU53P SPECIFICATIONS Specifications Specifications Model LU43P Frequency Response 100Hz-20kHz Woofer 4" (100mm) Rubber Surround Midrange 40mm Polypropylene Cone Tweeter 20mm Piezo Dome Sensitivity 80dB (± 3 dB @ 1 watt / 1 meter) Nominal Impedance 4 Ohms Power Handling* 50 Watts RMS / 100 Watts Peak power Dimensions (Inches H x W x D) 8.25 x 5.25 x 5.25 Weight 2.15 lbs.
Limited One Year Warranty This warranty gives you specific legal rights. You may also have other rights which vary from state to state. Dual Electronics Corp. warrants this product to the original purchaser to be free from defects in material and workmanship for a period of one year from the date of the original purchase. Dual Electronics Corp.
