PD2 Digital Transmitter COFDM Transmitter Module Model PD2-TX-5000S 5 Watt Output The most important thing we build is trust
how to contact COBHAM copyright notice FCC information For operator and troubleshooting information, customers are encouraged to refer to the details in this manual. For additional clarification or instruction, or to order parts, contact COBHAM. Copyright © 2003 - 2011 The following information is provided as a service to our law enforcement customers who require a Part 90 station license for video surveillance operations using the 2450 to 2483.5 MHz band.
TABLE OF CONTENTS manual conventions NOTE: Describes special issues you should be aware of while using a particular function. WARNING: Calls out situations in which equipment could be damaged or a process could be incorrectly implemented, but in which operator safety is not a factor. Introduction................................................................................................................ 4-5 Quick Start......................................................................................
INTRODUCTION The Palladium II Series of digital video transmitters provide exceptional video quality in high multipath environments. They are ideal for use inside buildings, in urban areas, and in other applications where multipath would normally cause video tearing or breakup. Fan Heatsink SMA Antenna connection All Palladium II Series transmitters are designed for spectrum-efficient 2.5 MHz channel spacing. Approximately 400 carriers are used to transmit video and two channels of voice and data.
INTRODUCTION Using your Palladium II Transmitter Follow the instructions given in the Quick Start section on pages 6-7. When power is first applied to the Palladium, the unit reverts to the indicated channel and RF ON state. The Alarm LED may be ON, which indicates that there is no active video input. Changing your Transmitter Configuration The Palladium Transmitter can store up to 8 different configurations, which can be selected with the Channel Control.
QUICK START Complete these steps: 1. Connect the transmitter antenna to the SMA connector on the Palladium unit (see photo right). NOTE: Palladium TX-5000A Modules feature a heat sink for proper heat dissipation. For optimal performance, do not block air flow over the fins of this heat sink. 2. Attach a 12 VDC power source (capable of 7 amp output current) to the power block (red) as shown to the right. The input voltage is 12 VDC nom.
SPECIFICATIONS Physical Unit Dimensions (approx.) 10 “ x 10” x 3.625 (not including connectors) Environmental Operational Temp -30 degrees C to 50 degrees C Power Input Voltage Power Consumption 12 VDC nominal 75w Control PC Control Interface Memory RS-232.
SPECFICATIONS Audio Encoding Input Bitrates Sampling Frequency THD Response Crosstalk S/N Stereo or Dual Mono pair 28 kbps to 72 kbps depending on configuration 32 kHz, 16 kHz or 8kHz < 0.1% max 20Hz to 15KHz, +/- 0.25dB depending on configuration > 55 dB min 60 dB RMS Composite Video Input Standards Specification Connector Composite PAL and NTSC decoding NTSC (with and without pedestal) or PAL Rec. ITU-R BT.
NOTES 9
NOTES 10
CONTACT US 11
Cobham Tactical Communications and Surveillance 486 Amherst Street • Nashua, New Hampshire 03063 • 603-880- 4411 www.cobham.