Operation Guide

ManualsBrandsDT Research ManualsElectronicsWLAN Module

Table Of Contents

I/O Ports

The Medical-Grade Integrated LCD System has a comprehensive set of I/O ports. The following

ports are located along the bottom side of the unit.

Medical-Grade Integrated LCD System

Front Back

�

A B C D E F

G H I C J K

507T

INTRODUCTION

Thank you for acquiring DT Research’s Medical-Grade Integrated LCD System. With a 23.8-

inch or 27-inch TFT display and powered by the Intel® Core™ i processor, the Medical-Grade

Integrated LCD System offers optimal combinations of performance and power savings. With

fully-integrated point-of-care modules within an elegant, space-saving design, the Medical-Grade

Integrated LCD System is the optimum solution to enhance workflow and service.

Please take a few moments to review the contents of this document to ensure that the setup

Cleaning the Screen

• A screen cleaning solution that is alcohol-free and non-abrasive can be used to clean the

touch screen.

• Cleaning with a micro-fiber cloth is recommended.

• Please spread the solution onto the cloth and then clean the touch screen.

Cleaning the Anti-microbial Enclosure

• Use a soft/non-abrasive cloth moistened with water to clean the enclosure.

• If using a cleaner, an alcohol-free and oxide-free cleaning liquid is recommended.

• To prevent scratching the anti-microbial coating, please wipe gently.

DT Research, Inc.

2000 Concourse Drive, San Jose, CA 95131

and startup proceed smoothly. The Medical-Grade Integrated LCD System is ready for use, out of

the box, in its default configuration when powered by the power source provided. The following

documentation offers guidance on the hardware elements and features of the computer. Please

refer to your device provider for information pertaining to the software operating system or

software applications.

PACKAGE CONTENTS

• 507T

• AC-DC power adapter with power cord

• Basic operation guide

MEDICAL – GENERAL MEDICAL EQUIPMENT

AS TO ELECTRICAL SHOCK, FIRE AND MECHANICAL

HAZARDS ONLY IN ACCORDANCE WITH ANSI/AAMI

ES60601-1 (2005) + AMD (2012) & “CAN/CSA-C22.2

No. 6060-1 (2008) + (2014)

Power button

USB 3.0 ports

Programmable buttons

Ethernet ports (RJ45)

Speakers

Audio jack

DC-in

USB 2.0 ports

HDMI output

COM ports

Potential equalization

conductor (optional)

Summary of content (4 pages)

PAGE 1
I/O Ports The Medical-Grade Integrated LCD System has a comprehensive set of I/O ports. The following ports are located along the bottom side of the unit. Front Medical-Grade Integrated LCD System Back Bo�om A B C D E F A Power button F USB 3.0 B G Programmable buttons Speakers H Audio D DC-in I HDMI output H I C J K 507T ports Ethernet ports (RJ45) C E G jack INTRODUCTION USB 2.0 ports Thank you for acquiring DT Research’s Medical-Grade Integrated LCD System. With a 23.
PAGE 2
PRECAUTIONS Powering ON and OFF • Always exercise care when operating and handling the Medical-Grade Integrated LCD System. • Never disassemble any portion of the enclosure, as this will void any product warranty on the Medical-Grade Integrated LCD System. • Do not use any AC/DC adapter other than the one provided with the device or a replacement acquired from the manufacturer. Please use the AC-DC adapter with the Medical-Grade Integrated LCD System for the power supply.
PAGE 3
Federal Communication Commission Interference This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
PAGE 4
RF Exposure Information(RED) To be protected against all verified adverse effects, the separation distance of at least 0.2m must be maintained between the antenna of the radio having max. 3.2dBi antenna and all persons. The band 5150-5350 MHz for this device are restricted to indoor use only within all European Union countries. Hereby, [DT Research, Inc.] declares that the radio equipment type [507T] is in compliance with Directive 2014/53/EU.