Model # DS18971 USE AND CARE GUIDE 3-LIGHT FLUSH MOUNT Questions or problems? Before returning to the store, call Design Solutions International Customer Service Mon-Fri 9:30 am to 3:00 pm EST 1-800-388-6141 ext. 216 For customer service support and the fastest response, please email us at CustomerSupport@DSILighting.
Table of Contents Table of Contents ........................................................... 2 Safety Information ......................................................... 2 Warranty ......................................................................... 2 Three (3) Year Warranty ............................................................. 2 What is Covered ........................................................................ 2 What is Not Covered ...................................................
Pre-Installation PLANNING INSTALLATION Read all instructions before installing. To avoid damaging this product, place it on a soft, non-abrasive surface, such as carpet or cardboard. IMPORTANT: Inspect the wire insulation for any cuts, abrasions, or exposed copper that may have occurred during shipping. If there is a defect in the wire, do not attempt installation. Please call the Customer Service Team at 1-800-388-6141 ext. 216.
Pre-Installation (continued) PACKAGE CONTENTS A B C Part Description Quantity A Fixture body 1 B Glass shade 3 C Socket ring (Pre-assembled to fixture body (A)) 4 3
Installation 1 2 Preparing the mounting strip □□ Screw the threaded tube (CC) into the mounting strip (AA), and secure it using the lock washer (EE) and hex nut (DD). Installing the mounting strip □□ Fasten the mounting strip (AA) onto the outlet box using two outlet box screws (BB). NOTE: The threaded tube (CC) should extend long enough to protrude through the canopy, when it is mounted. (Adjust as needed.) AA CC 3 EE AA DD BB Making the electrical connections □□ Strip 3/4 in.
Installation (continued) 4 5 Assembling the fixture body to the outlet box □□ Place the fixture body (A) over the outlet box, let the threaded tube (CC) come through the hole of the canopy of the fixture body (A), then tighten the hex nut (DD) and finial (HH) to the protruding threaded tube (CC) on mounting strip (AA) until the canopy of the fixture body (A) is held firmly against the ceiling.
Care and Cleaning □□ Do not use any cleaners with chemicals, solvents, or harsh abrasives. Use only a dry, soft cloth to dust or wipe carefully. □□ To clean the fixture, disconnect power by turning off the circuit breaker or by removing the fuse at the fuse box. Use a dry or slightly dampened, clean cloth to wipe the exterior surface of the fixture. Troubleshooting Problem Possible Cause Solution The lights will not turn on. The bulb is burned out. The power is off. There is a faulty switch.
Questions or problems? Before returning to the store, call Design Solutions International Customer Service Mon-Fri 9:30 am to 3:00 pm EST 1-800-388-6141 ext. 216 For customer service support and the fastest response, please email us at CustomerSupport@DSILighting.com Retain this manual for future use.