Model # DS18938 USE AND CARE GUIDE 3-LIGHT PENDANT Questions or problems? Before returning to the store, call Design Solutions International Customer Service Mon-Fri 9:30 am to 3:00 pm EST 1-800-388-6141 ext. 216 For customer service support and the fastest response, please email us at CustomerSupport@DSILighting.
Table of Contents Table of Contents ........................................................... 2 Safety Information ......................................................... 2 Warranty ......................................................................... 2 Three (3) Year Warranty ............................................................. 2 What is Covered ........................................................................ 2 What is Not Covered ...................................................
Pre-Installation PLANNING INSTALLATION Read all instructions before installing. To avoid damaging this product, place it on a soft, non-abrasive surface, such as carpet or cardboard. NOTE: This product requires three 60W maximum medium base (E26) type "A" bulbs or 9W maximum medium base (E26) self-ballasted LED bulbs (sold separately). IMPORTANT: Inspect the wire insulation for any cuts, abrasions, or exposed copper that may have occurred during shipping.
Pre-Installation (continued) PACKAGE CONTENTS A B C C C D E F Part Description Quantity A Canopy assembly 1 B 6” tube 1 C 12” tube 3 D Fixture body 1 E Threaded tube 1 F Diffuser 1 4
Installation 1 2 Preparing the mounting bracket □□ Fasten the support screws (long) (CC) into the mounting bracket (AA), and secure it using the hex nuts (G-5/32”) (DD). Installing the mounting bracket □□ Fasten the mounting bracket (AA) onto the outlet box using two outlet box screws (short) (BB). NOTE: The support screws (long) (CC) should extend long enough to protrude through the canopy assembly (A) when it is mounted. (Adjust as needed.
Installation (continued) 4 Making the electrical connections □□ Strip 3/4 in. of insulation from the wire ends. □□ Connect the black wire from the fixture to the black wire from the outlet box, then connect the white wire from the fixture to the white wire from the outlet box. □□ The bare copper ground wire from the fixture must loop one turn under the head of the green ground screw (EE) on the mounting bracket (AA) before it is connected to the ground conductor of the supply circuit.
Installation (continued) 7 Installing the diffuser □□ Fasten the threaded tube (E) into the bushing located on the socket as shown. □□ Slide the diffuser (F), the rubber washer (HH) and the metal washer (II) over the threaded pipe (E) and secure by the hex nut (G-3/8”) (JJ) as shown in the diagram (Do not tighten excessively). Then place the cap (KK) over the threaded tube (E) and secure by the finial (LL).
Questions or problems? Before returning to the store, call Design Solutions International Customer Service Mon-Fri 9:30 am to 3:00 pm EST 1-800-388-6141 ext. 216 For customer service support and the fastest response, please email us at CustomerSupport@DSILighting.com Retain this manual for future use.