Installation Guide

Installation steps
5DreamLine L-Bar™ Support Bracket manual Ver 1 Rev 1 02/2019
©2019 DreamLine. All Rights Reserved
Fig 1
Fig 2
(Left-hand L-Bar™ installation shown as an example)
4
3*
Max 3/16”
(4mm)
Max 3/16”
(4mm)
1 2
3
4
Ø5/16"
(8mm)
5
1
2
*Loosen the Flat head screws prior to adjustment
and then retighten after adjustment
TIP: Leave the cover plate on the
L-Bar
™ when marking its position
on the wall so that there will be
space to attach the cover plate
after the L-Bar is installed.
1. Position the L-Bar™ assembly (#03) onto the Panel Glass or Hinge Panel Glass as shown (Fig 1.1)
Level and mark the L-Bar
™ position on the wall.
Remove the Wall Plate (#06) from the L-Bar
™ (Fig 1.2). Position the Wall Plate (#06) onto the marks
on the wall. Mark the holes for drilling through the wider, untapped holes (Fig 1.3). Drill two
Ø5/16”(8mm) holes and insert the Ø5/16” Wall anchors (#05). (Fig 1.5)
2. Attach the Wall Plate (#06) to the wall using the ST4.2 x 40 Truss Head Screws (#07).
Re-attach the L-Bar
™(#03) to the Wall Plate (#06) using the Flat head Screw M5x14 (#08) and adjust
the angle if necessary by using the Wall Plate Adjustment set screws (#09) (Fig 2.7
& 2.8).
(Fig 2)