Installation Sheet

ManualsBrandsDreamLine ManualsBathEnigma-XO 55-59 in. W x 62 in. H Fully Frameless Sliding Tub Door in Brushed Stainless Steel

Product Maintenance

ENIGMA-XO Maintenance Checklist

◻ Guide Rail level and tight

◻ Guide Rail Brackets tight to the wall

◻ All set screws are tight and secured with threadlock

◻ Panel Glass secure

◻ Panel Glass-to-Rail Brackets tight

◻ Guide Block square to the threshold and glass

◻ Proper clearance beneath the Door Glass between the threshold and within the Guide Block

◻ Door Glass adjusted so that the Bulb Vinyl Seal makes even contact with the wall

◻ Roller Wheel Assemblies tight

◻ Roller Wheel Assembly bolts tight

◻ Roller Wheel Assembly safety set screws tight, accessible and set with threadlock

◻ Door Stoppers tight and positioned correctly

◻ Panel-side Door Stopper installed into the pre-drilled hole in the Upper Guide Rail

◻ Adequate Handle clearance when the door is fully open

◻ Door-side Door Stopper positioned at approximately 3” (+/- 1/8”) (as measured from the

wall to the center of the stopper)

◻ Check that the Stopper stops the door and the Bulb Vinyl Seal makes contact with the wall

◻ SafeStop™ Bumper secured to the wall

◻ Bottom Roller Wheel Assemblies should make contact with the Upper Guide Rail

◻ Remove Vertical Vinyl Seals to inspect the edges of the door glass for concealed damage

◻ Damaged Glass must be replaced!

◻ Replace damaged or missing vinyl seals

◻ Inspect and replace silicone as necessary to prevent water leakage

To maximize the life of your door, it is important to regularly inspect

the glass and other hardware for misalignment, proper attachment,

and/or damage. Contact DreamLine

with any questions or concerns.

NOTE

BASES and BACKWALLS: To ensure long lasting life for your acrylic back walls: wipe them off

after each use with a soft cloth. To clean the acrylic back walls use non-abrasive sprays or cream

based cleaners. Avoid the use of aerosol spray cleaners. Never use abrasive cleansers, metal

brushes or scrapers that could permanently scratch or dull the surface.

GLASS: To ensure long lasting life for your glass shower products: wipe them off after each use

with a soft cloth. Rinse and wipe off the glass using either a soft cloth or a squeegee to prevent

soap buildup and water spots (Hard water can etch the surface of the glass over time if left to dry).

To prevent scratching the surface: never use abrasive cleaners or cleaning products that contain

scouring agents. Never use bristle brushes or abrasive sponges that may scratch the surface of the

glass.

HARDWARE: To ensure a long lasting finish: wipe off all metal parts after each use with a soft

cloth. Do not use abrasive cleaners or cleaning products containing ammonia, bleach or acid. If

accidentally used, rinse the surface as soon as possible to prevent damage to the finish (peeling or

corrosion). After cleaning the polished finishes, rinse thoroughly and wipe dry with a soft clean-

cloth.

Clean stainless steel surfaces at least once a week. When applying stainless steel cleaner or polish

to stainless steel hardware, work with the grain (not across the grain). Never use an abrasive

sponge or cloth, steel wool or wired brush as these may permanently scratch the surfaces.

ENIGMA-XO Shower and Tub Door Manual Ver 1 Rev 7 022022 39