Installation Sheet

Tools Needed

Parts Needed

SafeStop™ Bumper Screw Installation - Option 2

ENIGMA-XO Shower and Tub Door Manual Ver 1 Rev 7 022022 37

Fig 26

REMOVE 3M™ TAPE

1 2 3 4* 5*

876

door glass

inline panel

wall

inside

*Right-hand door installation shown.

09b

Extender driver bit recommended

for screw installation.

NOTE

TIP

Use caution to not damage/crack the wall/tile and to avoid any plumbing behind the wall when using the

screw method .

For 72” Model: This will be the side of the opening with the large stationary panel. Mark the position of

the hole onto the wall. Drill the correct hole diameter (see Note above). Remove the 3M™ Tape and

position the SafeStop™ Bumper (#30) onto the threshold against the Wall Bracket (#19) and attach

using the ST4.2 x 40 Countersunk Screw (#17). (Fig 26)

NOTE

For installing the SafeStop™ Bumper::

◾If a stud is present behind the wall:

drill a Ø3/16”(4mm) hole up to the stud.

◾If no stud is present behind the wall:

drill a Ø5/16”(10mm) hole and install the Wall Anchor (#09b).