Installation Sheet

Parts Needed

Upper Roller Assembly Installation

ENIGMA-XO Shower and Tub Door Manual Ver 1 Rev 7 022022 31

Fig 21

Roller Assembly Wheel Adjustment

Raise glassLower glass

**add threadlock to

the safety set screw

and wheel bolt

x1set

NOTE

inside

TIP

Panel

Glass

Door

Glass

inside

Mark the location of the high spot on

the outer surface of the adjustment

disk with a felt tip pen to make

adjustment easier to see.

Use a 3/16” shim beneath the Door Glass (#05)

when adjusting the level of the door so that the

glass does not make contact with the guide

block.

The adjustment disks in the wheels are the same as the disks in the Glass-to-Rail Brackets and can be

rotated to adjust the Door Glass (#05) to create a seal with the wall. The Safety Set Screw on both Roller

Assembly Wheels MUST be re-tightened after installation to prevent the wheel bolt from becoming

loose. Apply Thread Lock Adhesive (#26) during installation. See detailed description on page 34.

inside

safety set screw

(must be on top)

Adjustment Disk

Neutral Position