Installation Sheet

Parts Needed

Guide Rail Bracket Adjustment

ENIGMA-XO Shower and Tub Door Manual Ver 1 Rev 7 022022 26

Adjust the installed Top Guide Rail (#03) to level as

necessary using the Guide Rail Brackets (#08) first

and then the Glass-to-Rail Brackets (#07).

Start adjustments from the door end.

TIP

To lower the rail:

Loosen the top set screw

and tighten the bottom

set screw.

To raise the rail:

Loosen the bottom set

screw and tighten the

top set screw.

Use the Guide Rail Bracket (#08) set

screws to adjust the Guide Rail (#03)

to level.

NOTE

x1set

72”

MODEL

ONLY

Fig 14

Panel end

Door end

Glass-to-Rail Bracket

Guide Rail Bracket

*Right-hand door installation shown

Lower guide rail Raise guide rail

Glass-to-Rail Bracket Adjustments

NOTE

For the 72” Model: Repeat this step for the Wall Bracket (#19) for the Small Inline Panel

Glass (#23) (Fig 14.4). Use the clear vinyl gasket between the glass and the metal parts to

avoid contact with the glass, then tighten the bolt using the supplied Allen Wrench (#11).

For Enclosure Model: Refer to Step 8 in the

Enigma-X/Enigma-XO Enclosure Return Panel

Manual to connect the shower assembly to the Return Panel using the Glass-to-Guide Rail

Connector (#28).