Installation Guide

ManualsBrandsDreamLine ManualsBathAqua 45-7/8 in. x 72 in. Hinge Shower Door in Chrome

AQUA

SHOWER / TUB DOOR INSTALLATION INSTRUCTIONS

IMPORTANT

DreamLine

reserves the right to alter, modify or redesign products at any time without prior

notice. For the latest up-to-date technical drawings, manuals or any other details please refer

to your model’s web page on BathAuthority.com

Please read these instructions carefully before installing. If you have any questions

regarding installation, please contact our technical support specialists Monday through

Friday 8:00 AM – 7:00 PM EST at Phone: 1-866-731-2244, Fax: 1-866-857-3638 or e-mail

our technical support group at Support@BathAuthority.com

For more information about DreamLine

products please visit www.BathAuthority.com

Model #s:

SHDR-3146720-##

SHDR-3148586-##

##-finish

01=Chrome

04-Brushed Nickel

Right hand door installation shown

Summary of content (11 pages)

PAGE 1
AQUA SHOWER / TUB DOOR INSTALLATION INSTRUCTIONS IMPORTANT DreamLineTM reserves the right to alter, modify or redesign products at any time without prior notice. For the latest up-to-date technical drawings, manuals or any other details please refer to your model’s web page on BathAuthority.com Model #s: SHDR-3146720-## SHDR-3148586-## ##-finish 01=Chrome 04-Brushed Nickel Right hand door installation shown Please read these instructions carefully before installing.
PAGE 2
Preparation 1. Prior to installation, examine all boxes and packages for shipping damage and compare the piece count with your packing slip. After opening all boxes and packages read this introduction carefully. Check that all of the needed parts are included in the package by checking off the components on the “Detailed Diagram of Shower Door Components”.
PAGE 3
Tools Required Tape Measure Caulk Caulk Gun Level “AQUA” Ver.
PAGE 4
Detailed Diagram of Shower Door and Tub Door Component 1 7 8 9 3 2 4 5 10 11 6 12 13 14 15 Packing List 01 02 03 04 05 06 07 08 Wall profile Stationary glass Support bar Hinge Glass door Towel bar Wall anchor Decorative caps 1pc 1pc 1pc 2pcs 1pc 1pc 5pcs 2pcs 09 10 11 12 13 14 15 Round Head screw ST4.2×10 Big head screw ST4.2×40 Anti-Water strip Bottom anti-water strip Round head screw ST4.2×25 Bottom bracket Countersunk screw ST4.
PAGE 5
Shower/Tub Door Installation 1. Place the Wall profile (01) to the wall above the shower base or tub and level it vertically. See Fig. 1 for details. Fig. 1 2. Mark the drilling holes on the wall through the holes in the Wall profile (01). Place the Wall profile aside, drill the holes using Ø5/16” drill bit and insert the Wall anchors (07). Apply silicone caulk along the wall profile and around the holes on the wall.
PAGE 6
3. Slide the Stationary glass (02) into the groove of the Wall profile (01). See Fig. 3 for details Fig. 3 4. Take apart the Bottom bracket (14). Place the Bottom bracket base into the notch on the bottom of the Stationary glass (02) from inside and mark the drill hole on the threshold, tray or bathtub. Remove the glass, drill the hole using Ø1/8” drill bit and secure the Bottom bracket base with Round head screw ST4.2×25 (13). See Fig. 4 for details. 1 3 Inside Ø1/8" Outside 2 4 Fig. 4 “AQUA” Ver.
PAGE 7
5. Place the Stationary glass (02) back into the Wall profile (01) and assemble the Bottom bracket (14). See Fig. 5 for details. NOTE: Make sure to use clear rubber gasket to prevent glass to metal connection. Fig. 6 Fig. 5 6. Locate the Support bar (03). Adjust the Support bar at the angle that will provide adequate support to the glass and the wall. Level it horizontally. Hold it firmly and outline the bracket’s position on the wall. Remove the Support bar and detach the wall bracket from it.
PAGE 8
7. Install both Hinges (04) on the Stationary glass (02) with the decorative non-screw side facing outwards. Hang the Glass door (05) from the inside. You will need assistance in this process. NOTE: Use 5/8” shim beneath the glass door to hold it in position while you attach the hinges. NOTE: Use clear rubber gasket to prevent glass to metal connection. Inside Outside 1 Begin at the top hinge when hanging the door.
PAGE 9
8. Install the Towel bar (06) onto the Glass door (05). Attach the Anti-water strip (11) over the vertical edge of the Glass door (05). Attach the Bottom anti-water strip (12) over the bottom edge of the Glass door. 1 3 Door Outside Inside Outside See Fig. 9 for details. 2 Inside Panel Outside Door Fig. 9 9.
PAGE 10
. Apply caulk inside and outside along bottom and vertical edge of the stationary glass and wall profile. See Fig. 11 for details. Caulk Fig. 11 Product Maintenance BASES and BACKWALLS: To ensure a long life for your acrylic back walls: wipe them off after each use with a soft cloth. To clean the acrylic back walls use non-abrasive sprays or cream based cleaners. Never use abrasive cleansers, metal brushes or scrapers that could scratch or dull the surface.
PAGE 11
TEL: 866-731-2244 FAX: 866-857-3638 WWW.BATHAUTHORITY.COM For more information on DreamLineTM Shower Door and Tub Door please visit www.BathAuthority.