Installation Guide

Tools Needed

Parts Needed

CREST Shower Door Manual Ver 1 Rev 2 022020 10

After determining the handing of the installation:

Only cut from the end of the Bottom Profile (#03)

that will be installed on the door side of the opening.

The length to cut-o of the door side of the Bottom Profile (#03) will be (L):

Finished Opening (W) (-) 1/16” = Finished Cut Length (L)

TIP

Use a metal file to

deburr the cut end

The Bottom Profile (#06) can be cut from either end depending on the installation.

Do Not cut off more than 2” from the Bottom Profile as this would remove

allowance for the Panel and Door Glass installation.

Do Not cut off more than 2”!

Fig 3a

Fig 3b

*In this example, the Bottom Profile (#06)

is shown for a right-hand door installation.

*Door End

*Panel End

cut from the door end only