Installation Guide

12PRISM shower enclosure manual Ver 1 Rev 4 05/2018

NOTE: Trim off the excess Sweep Vinyl Seal (#13) and attach a 1” piece onto the

opposite side of the Bottom Pivot. (Fig 8.3)

Fig 8

outside

inside

door

inside

outside

door

panel

Left-hand door installation shown

panel

inside

Magnetic

strike

vinyl

sweep vinyl

8. Push the Hinge-Side Vinyl Seal (#14) onto the pivot edge of the Door Glass (#04) with the soft fin

on the inside of the shower so that it overlaps the Panel Glass (#03) when the door is closed.

(Fig 8.1)

Cut the Sweep Vinyl Seal (#13) to fit from the bottom pivot to the strike edge of the Door Glass (#04).

(the mitered end of the Sweep Vinyl Seal goes on the strike side of the door)

Firmly push the Sweep Vinyl Seal (#13) onto the bottom edge of the Door Glass (#04).

Trim a 1” piece from the cut-off of the Sweep Vinyl Seal (#13) to fit onto the opposite side of the

bottom pivot and attach it to the bottom of the door glass. (Fig 8.3)

Note: The fin on the Sweep Vinyl Seal (#13) should be installed toward the inside of the shower.

(Fig 8.2)

Push the shorter Magnetic Strike Vinyl (#12) onto the strike edge of the Door Glass (#04). Notch the

bottom of this Magnetic Strike Vinyl (#12) to fit around the Sweep Vinyl Seal (#13). (Fig 8.5)

Attach the longer Magnetic Strike Vinyl (#12) to the strike edge of the Panel Glass (#03).

When correctly installed, the Magnetic Strike Vinyl (#12) will form an outside 45-degree angle.

Adjust as necessary to get a tight seal. (Fig 8)