Installation Guide

9PRISM shower enclosure manual Ver 1 Rev 4 05/2018

NOTE: The inside edge of

each wall profile must be

installed at the model size

dimensions W1 and W2

shown in Table 1

Fig 2b

Fig 3

Ø5/16”

64 5

39-7/16”

37-7/16”

35-7/16”

33-7/16”

39-7/16”

37-7/16”

35-7/16”

33-7/16”

SHEN-GLP2101-404010

SHEN-GLP2101-383810

SHEN-GLP2101-343410

SHEN-GLP2101-363610

Measure from the finished corner to the inside edge of wall profile as shown:

Glass Box SKU /Model #

Table 1 - Enclosure assembly measurements

Fig 2a

inside

3. Make sure each Wall Profile (#02) is plumb.

Mark the holes for drilling on the wall through

the predrilled holes in the Wall Profile (#02).

Drill the holes in the wall using a Ø5/16” drill

bit and insert the Wall Anchors (#08).

Run a bead of waterproof silicone along the

back of the Wall Profiles (#02) and around the

holes in the wall. Attach the Wall Profile (#02)

to the wall using the Truss Head Screws

ST4.2×40 (#11). (Fig 3)

2. Mark the wall at the threshold according to the

dimensions for the model size shown in Table 1 below.

Place the Wall Profiles (#02) against the walls and

aligned with the new reference marks on the threshold.

Use a level to plumb each wall profile. (Table 1, Fig 2a

and Fig 2b)