DTS860 Digital Transport Stream Instruction Manual is a registered trademark of the R.L. Drake Holdings LLC © Copyright 2013 R. L.
Table of Contents, Caution, & Important Safety Instructions Caution Statements ......................................................................................................................................2 Important Safety Instructions ...............................................................................................................2 Specifications .......................................................................................................................................
Important Safety Instructions (continued) 3 8. 9. 10. 11. 12. 13. 14. 15. 16. 17. 18. 19. 20. 21. 22. 23. 24. Accessories: Do not place this product on an unstable cart, stand, tripod, bracket, or table. The product may fall, causing serious injury to a child or adult, and serious damage to the product. Use only with a cart, stand, tripod, bracket, or table recommended by the manufacturer, or sold with the product.
Specifications 4 Input Connector: Standards: "F" Female 8VSB: ATSC Digital Television Standard A/53E QAM: ITU-T J.83 (64 and 256 QAM) 8VSB Mode: Tuning Range: Symbol Rate: Bandwidth: QAM Mode: Tuning Range: Symbol Rate: UHF (NTSC Ch. 14 - 78), VHF (NTSC Ch. 2 - 13) 10.762 Msymbols/sec 6 MHz CATV (NTSC Ch 2 - 135) 5.3606 Msymbols/sec (QAM 256) 5.
Front Panel Controls & Indicators 5 [1] [2] [3] [5] [6] [7] [8] [9] [4] [10] [11] [1] (CH-UP) button: Increments current tuned channel to the next higher channel. Holding this button down will fast scroll through the channels. Channel display will blink to indicate displayed channel is in selection and has not been entered. Press ENT button to confirm. If 5 seconds pass without pressing the ENT button, the display will return to its last programmed state and stop blinking.
Front Panel Controls (continued) [8] RF Mode button: When the RF button is pushed, the module will switch from the sleep mode to the frequency plan editing mode. The LED display will indicate current Channel number and RF frequency plan.
Operation 7 [1] Power-save mode: After approximately 3 minutes of no interaction, the unit will enter into its power-save mode by turning off all front-panel LEDs and displays. The dot of the 2-digit LED will remain lit to indicate unit is powered and operating normally. Pressing any button will bring the unit out of power-save mode and current channel and modes will be displayed. [2] Unit Reset: Holding the RF Mode and Baud Rate buttons simultaneously for 5 seconds will reset the unit.
Notes
Notes 9
Warranty Three Year Limited Warranty R.L. DRAKE HOLDINGS LLC warrants to the original purchaser this product shall be free from defects in material or workmanship for three (3) years from the date of original purchase. During the warranty period R.L. DRAKE HOLDINGS LLC or an authorized Drake service facility will provide, free of charge, both parts and labor necessary to correct defects in material and workmanship. At its option, R.L. DRAKE HOLDINGS LLC may replace a defective unit.
THIS PAGE INTENTIONALLY LEFT BLANK
R.L. Drake Holdings LLC 710 Pleasant Valley Drive Springboro, ohio 45066. uSA Customer Service and Parts Telephone: +1 (937) 746-6990 Telefax: +1 (937) 806-1510 Web Site: http://www.rldrake.