YW-012 USER’S GUIDE NIGHT LIGHT SPEAKER WITH WIRELESS CHARGING V 1.
FCC NOTICE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
• • • • Sleep time Light function in rear of main unit Dimmer control for display & rear light External power adapter for main power DC 9V, 2000mA Included • Digital Clock with Wireless Charger Unit • AC power Adapter • Instruction Manual Introduction 2
Location Controls 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. 16. 17. 18. POWER Button: Press to turn on / off the unit. AL1 (Alarm 1) Button: Press to set alarm clock 1 in standby mode. AL2 (Alarm 2) Button: Press to set alarm clock 2 in standby mode. CLK Set Button: In standby mode, press and hold to clock setup Press to change temperature display of Celsius (℃) or Fahrenheit (℉).
Wireless Charging your smart phone Follow Connect Power Adapter section to plug in DC INPUT jack of main unit, Place the smart phone (wireless charging compatible) on the charging pad in Vertical Position or Horizontal Position. the indicator indicates the Device is charging. will light which When the smart phone is indicated fully charging, please take away the device from the charging pad.
1. The USB charging port of this unit supplies a DC 5V output at 1000mA maximum current to charge your smart phone or portable device battery and it cannot support any other voltage range. 2. Make sure the device you want to charge has a battery charge rating of DC 5V only. 3. The USB port of this unit is designed for smart phone or portable device battery charging only and it cannot support data transfer or connect to computer. 4.
Alarm Setting 1. In standby mode, press and hold the AL1 or AL2 button, the 2. 3. 4. 5. or icon will light and the hour of the alarm time will blink to prompt for input. Repeatedly tap the VoL- or VoL+ button to adjust the hour. Press and hold the button for fast advance / reverse setting. Tap the AL1 or AL2 button to confirm the hour setting, the minute digits will blink to prompt for input. Repeatedly tap the VoL- or VoL+ button to adjust the minute.
indicator appears on the display, the unit will go into Standby mode automatically after selected time has expired. Dimmer Touch the DIMMER button to adjust the display intensity from High / Mid / Low to obtain the best clarity of display readout. Light Function Touch the LIGHT button to switch LOW / Mid / High / OFF brightness for the night light. Connecting Bluetooth to Your Smartphone / Tablet 1. Press the POWER button to turn on the unit, the BT indicator will flash on the display 2.
