Installation Instructions

1. Install the battery in the remote control and under the vehicle, turn
on the power switch under the vehicle, and then press the power supply
of the remote controlOn/off, the indicator light of the remote control
flashes slowly, starting to enter the code state if the remote control
indicatesThe light flashes and goes out to indicate the successful pairing.
2. Each remote control can only be matched with one vehicle's main
control code, after each code is successfully matc
hedThe bottom
controllers don't interfere with each other until they do.
3. The corresponding vehicle bottom master control code and the
remote control are still not found after about 1 minuteSleep will be
entered, the indicator will be off, press any button except the power
switchYou can re-enter the cross-code state.
4. Turn off the power of the two before recoding with the other remote
control or the main control under the car.
JV8026 Remote Control 2.4GHz( )
Underneath
Vehicle Image
Battery Usage Notices
On/Off
Power Button
Power Indicator Light
Slider B Slider A
Battery
Compartment Cover
JV9032 Vehicle
Battery Compartment
Cover
On/Off
Power Button
Use 2 pcs of 1.5V AAA non-rechargeable batteries for the remote controller.
Use 3 pcs of 1.5V AA non-rechargeable batteries for the toy.
IInsert/change batteries as per the correct polarity.
Non-rechargeable batteries are not rechargeable.
Do not mix old and new batteries, nor mix different types of batteries.
Take out the exhausted batteries from the toy.
The toy is not to be connected to more than recommended number of power
supplies.
The toy is not intended for children under 3 years old.
Regularly check the wire, shell and other components for any damage. Stop
using when the
damage is founded, the supply terminals are not to be short-circuited.
Unscrew the battery cover with the screwdriver, and insert the batteries as per
the correct polarity.
Do not mix alkaline batteries,standard (carbon-zinc) or rechargeable batteries.
403ARJV90320002
Install 2 pcs of 1.5V AAA non rechargeable batteries in the correct polarity
(remote control batteries are not included).
Install 3 pcs of 1.5V AA non rechargeable batteries in the correct polarity
(vehicle batteries are not included).
2402MHz to 2480MHz
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
--Consult the dealer or an experienced radio/TV technician for help.
MODIFICATION: Any changes or modifications not expressly approved by the
grantee of this device could void the user’s authority to operate the device.
<5dBm
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.