User's Manual

ALL KEY FOBS MUST BE PRESENT AND REPROGRAMMED WHEN PROGRAMMING NEW FOBS
Programming Instructions:
1. Open & unlock driver door.
2. Within 5 seconds, insert and remove the key in the ignition 2 times. (Do not turn on)
3. Close and open driver door 2 times.
4. Insert and remove the key in the ignition.
5. Close and open driver door 2 times.
6. Close the driver door.
7. Turn the key to the on position (without cranking ), and then turn off and remove the key from the ignition.
8. The power door locks will cycle when you have successfully entered programming mode.
9. Press lock & unlock buttons simultaneously for 1 second. Press unlock button for 2 seconds. Door locks will cycle 1 time to confirm
successful programming. Repeat this step to program all additional remotes.
10. Open the driver door and test all remotes. If programming has failed, repeat this procedure from the beginning.
FCC WARNING
Statement 15.19(a)(3): This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired
operation. Changes or modifications not expressly approved by Dorman Products Inc. could void the user’s authority to operate the equipment.