Installation Instructions

PKP READER

INSTALLATION

INSTRUCTIONS

FCC OVERVIEW

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES.

Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device

must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for Class B Digital Device, pursuant to Part 15 of the FCC

Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This

equipment generates and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in

a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, you can try to correct the interference by taking one or more of the

following measures.

q Reorient or relocate the receiving antenna.

q Increase the separation between the equipment and receiver.

q Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

q Consult the dealer or an experienced radio/TV technician for help.

THIS DEVICE COMPLIES WITH INDUSTRY CANADA LICENCE-EXEMPT RSS STANDARD(S).

Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) this device must

accept any interference, including any interference that may cause undesired operation of the device.

CET APPAREIL EST CONFORME À LA NORME RSS INDUSTRIE CANADA EXEMPT DE LICENCE.

Son fonctionnement est soumis aux deux conditions suivantes: (1) cet appareil ne doit pas provoquer d’interférences et (2) cet

appareil doit accepter toute interférence, y compris les interferences pouvant causer un mauvais fonctionnement du dispositif.

This Class [B] digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations.

Cet appareil numérique de la classe [B] respecte toutes les exigences du Réglement sur le matériel brouilleur du Canada.

PKP READER INSTALLATION INSTRUCTIONS

CAUTION /WARNING

1. Orient the new reader assembly and insert the reader

cable through the slot in the outside escutcheon.

2. Position the reader assembly on the reader gasket and

install the four reader assembly mounting screws.

CAUTION: Before you handle the electronics board or

any component connected to it, make sure that you are

properly grounded using an electrostatic discharge (ESD)

protection kit! Touching the board without proper ground-

ing can damage sensitive electronics components—even if

you don’t notice any static discharge!

CAUTION: Please keep the PKP Reader antenna 20cm

away from people to ensure that RF exposure compliance

requirements are not exceeded.

WARNING: Changes or modifications not expressly

approved by {Applicant name} could void the user’s

authority to operate the equipment.