Integration Manual for the HIDprox RFID Reader Module FCC ID NVI-RMS0003
About this manual Validity This manual describes the HIDprox RFID Reader Module into hosts, e.g. KABA B-web 93 00 Addressees This manual is written exclusively for specialists. The descriptions in this manual are intended for personnel trained by the manufacturer. The information in this manual cannot substitute the product training.
ESD (electro static discharge) protective measures CAUTION Danger for electronic components due to electrostatic discharge. Improper handling of printed circuit boards or components can cause damages that lead to complete failures or sporadic errors. During installation and repair of the device, the ESD protective measures must be considered.
Hardware Features Dimensions 100,0 x 50,0 x 10,0 (LxWxH) mm Antenna on board Interface type UART, TTL Reading distance up to 50mm depending on tag Power supply 5 VDC regulated
Dimensions: Description The RMs HIDprox is a RFID Reader/Writer with serial communication interface and one illumination unit for lighting behind a symbol. The illumination module consists of an analog current source, controlled by the Host-System via separate I2C Bus. The RFID carrier frequency is 125kHz and the targeted RFID system is HIDeprox. The carrier frequency is derived from a 8 MHz quartz oscillator.
Integration into KABA B-web 93 00 Labeling Using a permanently affixed label, the modular transmitter must be labeled with its own FCC identification number, and, if the FCC identification number is not visible when the module is installed inside another device, then the outside of the device into which the module is installed must also display a label referring to the enclosed module.
DECLARATION OF CONFORMITY according to FCC Part 15 This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
