“Safety 1%, Inc.” Canton Commerce Center, 45 Dan Road, Canton, Massachusetts 02021 FCC ID: MNJ48016T Model: 48016 Trade Name: 2.
Safety 15t® 2.4 GHz Child View Monitor and Television Television and Baby Monitor in one! Owner's Guide {LD of 3/4 view of Fortuitous and Camera) No. 48016 Introduction Thank you for purchasing the Safety 1st Child View Monitor and Television. This is a multi functional, state-of-the-art video monitor that features an automatic night mode that provides excellent night time viewing of a darkened. This unique monitor also features 3 channel selections for optimal performance as well 2.
Camera Features... Monitor Feature: Child Monitor Operation an Reception... Camera Location and Set Uj] Wall Mount installation. Table Top Set Monitor Location and Set Up. Monitor Operation. System Use, Television Use Problems and Solutions Guide. Important Safety Messages (caution flags/graphics) TO REDUCE THE RISK OF ELECTRICAL SHOCK, DO NOT REMOVE COVER OR BACK. NO SERVICEABLE PARTS INSIDE. REFER SERVICING TO SAFETY 1ST Customer Service (800) 723-3065.
9. Position the Camera, Monitor and AC adapters to allow adequate ventilation and prevent these components from overheating. 10. To prevent overheating, keep the Camera, Monitor and A/C adapters away from heat sources such as radiators, heat registers, stoves or other appliances (including amplifiers) which produce heat. Also keep these components out of direct sunlight. 11. Use only the AC adapters provided. Use of any other adapters may damage the Camera and/or Monitor.
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference which may cause undesired operation. Care and Maintenance Child View Monitor and Television is intended for indoor use only. Do not place the Camera where it will receive direct sunlight indoors. Outdoor use may damage the Camera and/or Monitor.
Safety 1st Canada, Inc., 804 rue Derailleurs, Villa St-Laurent, Quebec H4N1X1 Canada 800-721-3389 Safety 1st Europe, Ltd. Addison House, Shelley Road, Dreamworld, Worcestershire WD61TE Great Britain +44(0) 20 8236 0707 Made in CHINA to Safety Ist quality specifications. ©1999 Safety 1st, Inc.
10 Speaker 11 AC Adapter Jack 12 Video Adjustment Knobs: Vertical Hold, Brightness, Contrast 13 AC Adapter (LD of Monitor front; left side; top; back; AC Adapter) Monitor 123456789 10111213 AC Adapters The AC Adapters are a low voltage power source that allows you to use your household electricity to run the Child View Monitor and Television.
. before initial use, . regularly during use . whenever you change the location of the Camera or Monitor. To Test: It is easiest for two. adults to test reception. One adult should be present in the room with the Camera, while the other adult moves the Monitor to several different locations throughout the house. As with any audio equipment, feedback or a high pitched shrill sound may occur if the Camera and Monitor are too close to each other.
. Allow adequate ventilation of the Camera when mounted on a wall. DO NOT mount the Camera directly above heating vents, other heat producing sources or in direct sunlight. . Make certain that the Camera will be mounted so that the AC adapter cord will reach an outlet. To prevent entanglement and overheating, NEVER use an extension cord. Camera Wall Mount Installation * Hold the Camera flat against the wall in the location selected for mounting. .
Camera Table Top Set Up The Camera can be positioned on any stationary flat surface, such as a dresser, table top or shelving unit. Position the camera approximately §* (2M) away from the desired object. Important note: To prevent entanglement, never place the Camera in a crib or playpen. Always position the Camera and its A/C adapter cord out of child’s reach. NOTE: Use only the AC adapters included with the TV Surveillance System and Television. . Unwrap and fully extend the AC adapter cord.
(LD of 3/4 view of back of Monitor) (LD of 3/4 view of front of Monitor) System Use . Set Camera and Monitor to the same channel. . Slide the ON/OFF switch on the top of the Camera to the “ON” position. . Adjust the Fine tuning knob on the back of the Monitor for the clearest picture of your baby. To Adjust: . Turn the tilt adjustment knob counter-clockwise to loosen the camera. Move the camera up or down to the desired position and tighten the camera in place by turning the tlt adjustment knob clockwise.
Problem Possible cause Solution Warranty ONE (1) year limited warranty Safety It. WARRANTY. If Safety 1st, Inc.