Doran 360SL Programming Tool Operations Manual
I. INTRODUCTION The Doran 360 tool was designed to work with the Doran 360SL system. This tool is used to program all of the information for the trailer wheel sensors into the SmartLink booster. Once programmed, the booster will relay the information from the assigned sensors on the trailer to a tractor s monitor in the cab. The 360SL system is a great tool for fleets, large or small. It provides effortless versatility to monitor trailers that are not married to one tractor.
II. DESCRIPTION Window where LED lights can be seen 360SL Booster that tool will program. Power Cord III. ENTERING DATA INTO THE TOOL Specific data must be entered into the tool so the data can be transferred into the booster for proper operation on the trailer. Entering data is as easy as sitting at your desk and inputting the information for transfer to the Booster. Turn on the SL tool using the button on the lower left side of the tool. The Doran Programming tool welcome display will be shown.
III. ENTERING DATA INTO THE TOOL The reason for this is that the tool will grab the first signal that it sees, and it may not be the one that you are intending to work with. If there are not any trailers within a 50-foot radius you should not have any trouble using the tool without setting the trailer ID number.
III. ENTERING DATA INTO THE TOOL 5. When you are sure the number that you input into the tool is correct you can press the ENTER button to lock this number into the programming tool. 6. To select the Trailer ID number use the up and down arrow buttons to move the arrow to select this and press the ENTER button. The first digit of the 6-digit trailer number will begin to flash. Again, if a number is present it could be the number from a previous Read Information . 7.
III. ENTERING DATA INTO THE TOOL SEND INFORMATION TO BOOSTER: This mode allows all information that was input or entered into to the Programming Tool to be transferred to the Booster. The SmartLink Booster is the only booster that can be programmed using the tool. 1. Be sure that the booster is powered and operating. Check to see if the red light is on in the window next to the power cord attached to the booster. 2.
IV. LIMITED WARRANTY ONE YEAR LIMITED WARRANTY: Subject to the limitations and exclusions set forth in this Limited Warranty, the DORAN 360SL Program Tool is warranted against defects in material or workmanship that result in a product failure under normal use during the one-year period following the date of purchase by the original end-user. This Limited Warranty applies only to claims made by the original end-user and cannot be assigned, transferred or conveyed to any subsequent users.
IV. LIMITED WARRANTY PROCEDURE: Products determined to be defective within the terms of this Limited Warranty should be returned to Doran Mfg. LLC, transportation prepaid. Call DORAN Mfg. LLC for return authorization. No unauthorized returns shall be accepted. Sender is responsible for all costs incurred in the removal or reinstallation and shipping of the returned product. A copy of the sales slip from the point of purchase must accompany the returned product.
FCC WARNING This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: The manufacturer is not responsible for and radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user’s authority to operate the equipment.