Installation Instructions

CONTROLLING THE SERIES:

. Make sure all product connections are made prior to connecting power.

. Pull the plastic tab from the 2.4G handheld remote control battery compartment prior to

operation.

. Be sure to point the remote control in the direction of the front of the in-line receiver (white

square).

·Power the product ON, then select whether you are using 1 set or 2 sets connected together.

. For best results, select a color mix prior to selecting a chasing mode.

. Remote Control Signal Distance: Up to 10m/32.8 ft

1. Power ON and OFF

2. Holiday : Red, White, and Blue

3. Holiday : Red and Green

4. Holiday : Orange and Purple

5. Static (solid) Green

6. Static (solid) White

7. Static (solid) Red

8. Select "1Set" if using one set or "2Set" if using two connected sets

9.3-Color Mix: Red, Blue, and Green

10.7-Color Mix: Red, Green, Blue, Orange, Yellow, Light Blue, and Purple

11. Static (solid) Color Toggle: WW White, White, Red, Blue, Green, Yellow, Orange, Purple,

Pink,Blue, or Tuquoise

12.16-Color Mix: Red, Green, Blue, Orange, Dark Yellow, Light Yellow, Light Green, Green,

Tuquoise,Baby Blue, Dark Blue, Pink, Purple, Burgundy, and White

13.Jump Mode: Fades selected color mix

14.Rainbow Mode: Chasing 256 color mix

5.Auto Mode: Automatically cycles through Rainbow, Flash,and Jump modes, then Directional

Chasing Effects using the previously selected Color Mix

16.Flash Mode: Flashes selected color mix

17-18. Chasingselect color mix w ith white interval (< Power Side to End/ End to Power

Side >)19-20. Chasingselect color mix without white interval (< Power Side to End 1 End to Power

Side >)21-22. Speed: Adjust fast or slow in Chasing, Flash, or Jump modes

23-24. Chasing select color mix that fills to the end (< PowerSide to End/ End to PowerSide >)

Schematic diagram description

The controller button function: warm white - white - red - blue - green - yellow - orange

- purple - pink - cyan (light blue) - gradual change - chase, long press 3 seconds to shut

down, shut down and then turn on to keep the function mode before shutting down;

Three, power off memory function: turn off the power and then power on must

maintain the function mode before power off.

FCC Requirement

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits aredesigned to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses and can

PAGE 1
CONTROLLING THE SERIES: . Make sure all product connections are made prior to connecting power. . Pull the plastic tab from the 2.4G handheld remote control battery compartment prior to operation. . Be sure to point the remote control in the direction of the front of the in-line receiver (white square). ·Power the product ON, then select whether you are using 1 set or 2 sets connected together. . For best results, select a color mix prior to selecting a chasing mode. .
PAGE 2
radiateradio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radioor television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by oneor more of the following measures: .