PARTS LIST TL 2 fd mmm INCLUDES 1. Echelon® Reflect Fitness Mirror 4. Toggle bolt anchor {4} 2. Wood screw {2} 5. Washer (5) 3. MB screw (4) &. Wall mount 4.
INSTALLING THE MOUNT The Echelon® Reflect is required to be mounted directly to a wall stud or suitability floor stand. NOTE: Standard installation height is 83° to the top of the wall mount. STUD MARKS 5g ve 58° TEMPLATE ® TEMPLATE Locate stud within the wall you intend to hang your Reflect on and mark with a pencil. Lea and tape up the wall mount tern plate with the middies two holes centered over stud. 2. Mark all six holes. Using a 1/8" drill kit, drill the two pilot holes for the wood screws.
BACK OF UNIT &. Place the Reflect onto the wall 7. Using a Philips screwdriver, mount as shown above, drive in the screw located above bracket to secure. HOT: The Reflect may lase be attached to a 200 x 200mm VASE mount stand. We also have an installation and setup tutorial videos available at HTTP: or simply scan the QR code.
TURNING ON THE REFLECT TO TURN ON THE REFLECT, FLIP THE SWITCH ON THE BACK OF THE REFLECT TO THE RIGHT THEN TOUCH THE ECHELON® LOGO ON THE FRONT. THE LOGO Will TURN BLUE WHEN PRESSED. [SHOWN BELOW] TURNING OFF THE REFLECT TO TURN OFF THE REFLECT, PRESS AND HOLD THE ECHELON® LOGO FOR SIX SECONDS.
ACCOUNT SETUP Go to member.echelonfit.com and follow the onscreen instructions to choose a plan and setup your account. This info will be needed to login to your account after connecting to your Reflect to WIFI if you purchased Reflect on our website, you will receive an email with a link to activate your account. All account info and plans are managed at member. echelonfit.com and use the same login. After creating your account login on member.echelonfit.com, write down your login info.
CONNECTING YOUR HEART RATE MONITOR 1. If using the chest strap heart rate monitor, the Reflect will automatically syn to it when you press the heart monitor icon underneath the “Start Workout" button or when you join a class. Please follow the instructions for proper use of the chest strap heart rate monitor. 2. if using the armband heart rate monitor, press the Bluetooth connection button on your heart rate monitor.
FCC FEDERAL COMMUNICATIONS COMMISSION (FOC) STATEMENT 15.21 WARNING: CHANGES OR MODIFICATIONS TO THIS UNIT NOT EXPRESSLY APPROVED BY THE PARTY RESPONSIBLE FOR COMPLIANCE COULD VOID THE USER'S AUTHORITY TO OPERATE THE EQUIPMENT.
THIS DEVICE CONTAINS LICENSE-EXEMPT TRANSMITTERISYRECEIVER(S) THAT COMPLY WITH INNOVATION, SCIENCE AND ECONOMIC DEVELOPMENT CANADA'S LICENSE-EXEMPT RS5(S). OPERATION i$ SUBJECT TO THE FOLLOWING TWO CONDITIONS: 1. THIS DEVICE MAY NOT CAUSE INTERFERENCE. 2. THIS DEVICE MUST ACCEPT ANY INTERFERENCE, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION OF THE DEVICE.
5. Never operate this appliance if it has a damaged cord or plug, if it is not working properly, if it has been dropped or darn aged, or dropped into water. Return the appliance te a service center for examination and repair. &. Do not carry this appliance by supply cord or use cord as a handle, 7. Keep the cord away from heated surfaces. 8. Never operate the appliance with the air openings blocked. Keep the air openings free of lint, hair, and the like. 9.
WARNINGS + NEVER use Echelon® Reflect when sick or fatigued. « ALWAYS warm up/stretch before starting exercise. « NEVER overexert yourself or work to exhaustion. If you feel faint, dizzy, short of breath, or if you have chest or other pains, STOP IMMEDIATELY! Consult your physician before using the Echelon Reflect again. « ALWAYS ensure that the Echelon® Reflect is wiped down after sate use to keep it sanitary.