User's Manual

HOMEDEPOT.COM
Please contact 1-855-556-1852 for further assistance.
Use and Care
Guide
Wireless Battery-Powered
Doorbell Kit
ITEM #1001 406 908
MODEL #216600
Installation
1
ACTIVATING THE PUSH BUTTON BATTERY
□ Remove the front cover of the push button by inserting a flat
head screwdriver in the slot on the bottom of the button and
pulling up slightly.
□ Remove the plastic tab from the battery compartment to
allow connection to the terminal.
□ Snap the front cover onto the base by first hooking the tops
together, then snapping the base on.
2
INSERTING THE CHIME BATTERIES
□ Push the tab on the bottom of the chime and pull the back
cover off of the chime.
□ Insert (3) AA batteries as shown in the diagram on the chime.
3
SYNCING CHIME AND PUSH BUTTON
The chime and included push button already come synced.
Follow the steps below if you need to resync, or sync
additional push buttons.
□ Press and release the learning button on the inside of the chime.
□ Immediately following, press and release the push button to
hear a 2-note tune. Press and release the push button again
within five seconds to hear another tune. Continue pressing
and releasing the push button until you reach the desired tune.
To set that tune, do not push the push button for five seconds.
4
MOUNTING THE CHIME
□ Snap the back cover onto the chime.
□ Mark the desired screw location on a clean wall.
□ Drill a pilot hole on the mark using a 3/16 in. drill bit and
insert the wall anchor.
□ Screw in the included #6 screw and mount the door chime to
the screw.
TOOLS REQUIRED
Phillips screwdriver Flat Head Screwdriver (3) AA Batteries
HARDWARE INCLUDED
(2) #4 x 3/4 in. Screws (1) Adhesive Sticker (1) #6 x 3/4 in. Screw
Drill 3/16” Drill Bit 5/64” Drill Bit
(1) Wall Anchor
Learning
mode
button