User's Manual
T03 Sensor Installation Instructions
T03 Sensor Installation Process:
1、The steel tie around the hub. 2、Put the sensor on the steel tie 3、Pre tighten steel tie screw
4、Installing non-slip rubber pad 5、Tighten the steel tie screw 6、Installation completed
Remarks:
1. The installation position of the sensor should be close to the valve position, which is
convenient for the receiver to match with the sensor after installing tire.
2. After the sensor installation must check whether the sensor is loose, we must tighten the
steel tie screw.
3.Power Supply;DC 3V (The button battery *1)