User's Manual

MS-133OR Wireless Mouse and MX-133 Dongle User’s Manual

1. Battery install

Take out battery from package, put battery into battery box of wirelss mouse as per correct

polarity of battery. When battery becomes low power, receiver's LED indicator will flash to

remind user to change battery.

A. Refer the below photo (A), take off receiver from the top down

B. Then take out battery cover, put battery into battery box as per correct polarity of

battery, red LED at bottom of wireless mouse lights up (Photo B)

C. Close battery cover, battery be successfully installed (Photo C)

(A) (B) (C)

2. Mouse(MS-133OR)&

Dongle(MX-133) connect

The receiver and wireless mouse were well paired in factory, user can directly use.

A. Take out battery from package, insert the receiver into the USB port of computer, the LED

indicator of receiver will light up about 3 seconds then off, meanwhile computer will indicate

"new hardware found, automatically install"

B. You can use the mouse now.

If user wrongly operated, please redo above processes

Note:

Press the link button for 4 seconds, mouse will enter into sleep situation. To wake up the

mouse again, need to repress link button. This step will save battery power.

Link Button

PAGE 1
MS-133OR Wireless Mouse and MX-133 Dongle User’s Manual 1. Battery install Take out battery from package, put battery into battery box of wirelss mouse as per correct polarity of battery. When battery becomes low power, receiver's LED indicator will flash to remind user to change battery. A. Refer the below photo (A), take off receiver from the top down B. Then take out battery cover, put battery into battery box as per correct polarity of battery, red LED at bottom of wireless mouse lights up (Photo B) C.
PAGE 2
3. Resolution adjust Mouse working speed is able to adjust by yourself. There are two resolutions to select, 800DPI and 1600DPI. Press both left and right buttons together for about 3 seconds, LED under scroll wheel will flash. LED flashes slowly indicate 800DPI, quickly 1600DPI. 5. Dongle(MX-133) install To save battery power, you may put the receiver into battery cover, battery power will be cut off, which can prolong battery life.
PAGE 3
determined by turning the equipment off and on. The user is encouraged to try to correct the interference by one of the following measures: Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.