Installation Instructions

Manufacturer of FD: Dongguan Lingjie Electronic Technology Co., Ltd.

Made in China

Address: Building B, No. 16, Zhenxing North Road, Xiegang Town,

Dongguan, Guangdong,China

Execution standard number of the mouse: GB/T 26245-2010

2402.8MHz-2480.8MHz

model:I268

Wireless mouse

1.Open the back cover

and install the battery

2.Take out the receiver

3.Inset the usb receiver

into the usb port of PC

Warning:Changes or modifications to this unit not expressly

approved by the party responsible for compliance could void the

user’s authority to operate the equipment.

NOTE:This device complies with part 15 of the FCC Rules.

Operation is subject to t

he following two conditions: (1) This

device may not cause harmful interference, and (2) this device

must accept any interference received, including interference

that may cause undesired operation.

FCC Statement:This equipment has been tested and found to

comply with the limits for a Class B digital device, pursuant to

part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a

residential installation. This equipment generates, uses and can

radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful

interference to radio communications. However, there is no

guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to

radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try

to correct the interference by one or more of the following

measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different

from that to which the receiver is connected.

—Consult the dealer or an experienced radio/TV technician for

help.

RF exposure compliance statement:

This device has been evaluated to meet the general RF exposure

requirement

.0V