User's Manual

User's manual
Product: Anal Plug
Model: VAS12011, VAS12012, VAS12013, VAS12014, VAS12015, VAS12016, VAS12017, VAS12018, VAS12019
1. Remote Control:
- press #1 for 3 secs to turn on power, light is on.
- click #1 to operate thrusting/inflating, recycling from speed 1 to speed 6
and from speed 6 to speed 1.
Double click #1 to only stop thrusting/inflating.
- click #2 to operate vibrating, recycling from speed 1 to speed 10 and from
speed 10 to speed 1.
press #2 for 3 secs to only stop vibrating.
- press #1 for 3 secs to turn off power, light is off.
2. Press-key on body.
- press #1 for 3 secs to turn on power, light is on.
- click #1 to operate thrusting/inflating, recycling from speed 1 to speed 6 and
from speed 6 to speed 1.
Double click #1 to only stop thrusting/inflating.
- click #2 to operate vibrating, recycling from speed 1 to speed 10 and from
speed 10 to speed 1.
Double click#1 to only stop vibrating.
- press #1 for 3 secs to turn off power, light is off.
FCC Caution.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the
equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and
can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.

Summary of content (1 pages)