User's Manual

Manual

What's in the box

1 x Light projector

1 x Power adapter（AU.EU.UK.US)

1 x Remote controller

1 x User manual

Assembly & Installation

1. Installing the ground stake or lampstand:

First remove the screw on the ground stakes and put them into the corresponding

screw holes of the lamp. Then fix the screw with your fingers, and screw the

ground stake or lampstand clockwise(to remove it, loosen it counterclockwise).

2. You can change the projection angle of the lamp by 180° up and down.

3. Pull the power cable through and after plugging the waterproof plug, wind the

nut in tight.

4. Test the power.

1 2

1 x Ground stake

1 x Lampstand

18 x Films

PAGE 1
Manual What's in the box 1 x Ground stake 1 x Lampstand 18 x Films 1 x Light projector 1 x Power adapter（AU.EU.UK.US) 1 x Remote controller 1 x User manual Assembly & Installation 1. Installing the ground stake or lampstand: First remove the screw on the ground stakes and put them into the corresponding screw holes of the lamp. Then fix the screw with your fingers, and screw the ground stake or lampstand clockwise(to remove it, loosen it counterclockwise). 2.
PAGE 2
CARE & MAINTENANCE LUCKLED Smart Remote Controller Only use the included Power Adapter and ensure that it's properly connected to a grounded outdoor power outlet. Open Off Motor mode setting (for moving model only) Flash mode setting Do not point the projection light towards people, vehicles, or traffic routes. Do not use chemicals or detergents to clear up the product. Notice Timing function Timing off 1. Please only use the supplied transformer to connect to a proper grounded external plug. 2.