Installation Instructions

FCCRequirement
Any changes or modifications not expressly approved by the party responsible for compliance could
void the user
’
s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful in terference, and
(2) this device must accept any interference received, including interference that may caus
e
undesired operation.
Note: This equipment has been tested and foun
d to comply with the limits for a Class B digital devic
e,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and ca
n
radiate radio frequency energy, and if not installed and used in accordance with the instructions
,
may cause harmful interference to radio communications. However, there is no guarantee tha
t
interference will not occur in a particular installation. If this equipment does cause harmfu
l
interference to radio or television reception, which can be determined by turning the equipment of
f
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver
i
s
connected.
– Consu lt the dealer or an experienced radio/TV technician for help.