User's Manual

User Manual

Model number:YL-WM1408

1.1 Battery Installation

⑴.Open the battery cover on bottom of mouse, and pull out the Nano receiver.

⑵.Put battery in according to the polarity of the battery, then close the cover.

2.2 Device connection:

⑴. Put Nano receiver into the computer's USB port, and ensure good contact。

⑵. Computer will recognize a USB mouse device.(can be seen from the devicemanager)

⑷. Moving the mouse, you can enjoy wireless freedom.

⑸. If the connection failed，connection methods as follows：

Turn ON/OFF button to ON, and re-install battery, then replu Nano receiver;Mouse

can be work normally.

3.3. Sleeping mode:

Press any button to wake-up from Sleeping mode

4.4. receiver collection function:

⑴.For convenient to carry, can put Nano receiver into the collection tank of mouse.

5.5 Environment condition:

⑴.Operation temperature:0 ℃～50℃，humidity:20％RH～90％RH without condensations.

6.6 Matters needing attention:

⑴.Applications of the mouse will be affected on the rough or reflection surface.

⑵.Don’t disassemble mouse and receiver

⑶.Use dry and soft cotton product clean mouse.

⑷.Careful choice battery. its quality affects operation time and mouse life.

Instructions on “wireless”

Transmission frequency is 2.4GHz,it meet RE Directive 2014/53/EU noun in Europe and its

radiation does not harm human body .(far less than the mobile phone’s radiation)

Instructions on battery

Don’t throw the waste battery into recycle bin while replace battery.

FCC STATEMENTS

This device complies with Part 15 of the FCC Rules. Operation is subject to the following

two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may

cause undesired operation.

Caution: changes or modifications not expressly approved by the party responsible for

compliance could void your authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates uses and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful interference to radio

PAGE 1
User Manual Model number:YL-WM1408 1.1 Battery Installation ⑴.Open the battery cover on bottom of mouse, and pull out the Nano receiver. ⑵.Put battery in according to the polarity of the battery, then close the cover. 2.2 Device connection: ⑴. ⑵. ⑷. ⑸. Put Nano receiver into the computer's USB port, and ensure good contact。 Computer will recognize a USB mouse device.(can be seen from the devicemanager) Moving the mouse, you can enjoy wireless freedom.
PAGE 2
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver.