Installation Instructions

JR1602FCC Remote Control Manual
a. First time use need to match code, this product has memory function
c. Turn on the car body power now，The first LED lit up, Match code Success
e. Keys caption ：“△ ” Forward,
“ P ” Brake.
d. Remoter 10 seconds not run will be standby ,Press any key wake up
“ ” Back,“ ” Left,
“ ” Right,
“ S ”Speed,
Press “ S ” key set up speed , 1 led lit up is low speed，2 leds lit up is medium speed，
3 leds lit up is high speed, Back a car is only low speed
△
△
△
Press “ P ” key hold the brake, All LED flicker
Replace battery is unnecessary match code
(1). Supply Voltage---DC 3.0V , Battery 2*1.5V AAA (not included)
(2). Frequency 2.407GHz-2.473GHz (Peak output power: 5dBm)
(3). Instructions
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
※ The remote controller only can be used with adult's guidance
Note: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Warning: Changes or modifications to this unit not expressly approved by the part
responsible for compliance could void the user’s authority to operate the equipment.
FCC Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirement.
The device can be used in portable exposure condition without restriction.
Forward
Back
Speed
Brake
Left
Right
Speed display
b. Hold down “▲ ” & “ ” keys for 3 seconds start match code, The first LED flicker
▲