USER’S GUIDE Web Monitor Model No : MW-700
IMPORTANT SAFEGUARDS 1. Read all of these instructions. 2. Save these instructions for later use. 3. Unplug this monitor from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning. 4. Do not use attachments not recommended by the monitor manufacturer as they may cause hazards. 5. Do not use this monitor near water, e.g., near a bathtub, washbowl, kitchen sink, or laundry tub, in a wet basement, or near a swimming pool, etc. 6.
WICHTIGE INFORMATIONEN Bitte lesen Sie alle diese Informationen, bevor Sie das Gerät in Betrieb nehmen! Lesen Sie sich außerdem die Bedienungsanleitung komplett und sorgfältig durch, da nur in diesem Fall eine problemlose Inbetriebnahme erwartet werden kann. • Achten Sie darauf, daß das Gerät nur in eine 230V Schuko-Steckdose eingesteckt wird. • Die Steckdose sollte jederzeit frei zugänglich sein um bei einem evtl. auftretenden Notfall das Gerät schnell vom Netz zu trennen.
CONTENTS Emission Characteristics Tested by SEMKO A sample of this type has been tested and has shown compliance with the guidelines in the swedish document MPR II. This product is also designed for IT power system with phase to phase voltage of 230V. The power cord is used as a main disconnect device. Disconnect the power cord before servicing. The outlet must be installed near the monitor and must be easily accessible.
1. PRODUCT FEATURES This product is a new type of Thin Client that is used in conjunction with Windows NT4.0 Terminal Server Edition or Windows 2000 server. Installation of application programs, execution, data processing and storage are all implemented in the server, whereas the terminal is in charge of efficient data exchange with the server, screen display, and inputs by keyboard and mouse. Each user can execute application programs in a separate and protected realm.
3. INSTALLING THE TILT/SWIVEL STAND 4. CONNECTING TO THE PERIPHERALS 1. Ensure that the power is off to the monitor. 2. Set the monitor face down with the underside facing you. Please be careful not to scratch the monitor screen. 3. Align the four hooks on the stand with the guide holes on the bottom chassis of the monitor. Speaker port 4. Insert the hooks into the guide holes. Microphone port 5. Slide the tilt/swivel stand toward the front of the monitor until the latch locks in position.
5. TERMINAL INSTALLATION WIZARD Setting IP address Starting terminal installaion wizard This step is about specifying the IP address necessary for the use of the terminal. Using Automatic Setup Function After Setup, when the power is on, terminal installation wizard begins as follows. Users can set the environment necessary for the use of this terminal from the terminal installation wizard.
Setting monitor resolution and frequency Assigning the IP address This section should be setup properly by asking the Network Manager. Because “Terminal Name” is a proper name to be identified by the network, preferably a meaningful name must be assigned. The user himself/herself types the IP address and relevant information. In this section, the user sets up the resolution and frequency of the monitor connected to the terminal. Ask the Network manager.
Choosing the web-browser Advanced Setting for the web-browser In this section, the built-in web-browser is set up. To use default setting, please click “No.” To customize setting, please click “Yes.” In this section, the user chooses the method to indicate hyperlink and the size of the default font. Setting URL (Uniform Resource Locators) Cache and bookmark settings In this section, the home page and default search page of the web-browser are chosen.
6.CONNECTION MANAGER Proxy server setting Starting connection manager In this section, settings for network using proxy server are set. When the terminal is on, in most cases, connection manager screen such as the following appears. Connection manager largely performs two functions: (1) choosing server/service to be used by “Connections” tab and (2) choosing various items regarding connection by “Configure” tab. Ask the Network manager.
