Operating Instructions

KG1201-A Operating instructions

If you want to control your water pump and dust collector by KG1201-A,you need to pair the

switch to your transmitter first.

1. How to clean code: press the paring button 8 times , light flashes,cleaning code completely

2.How to set working mode:

Powen on the switch first

*Momentary mode:Press the "pairing button" one time fast,red led light on,then press the

transmitter button, red LED blinks fast ,then off.

(press remote button, switch on;release button,switch off)

*Toggle :Press the "pairing button" 2 times fast,red led light on,then press the transmitter button,

red light blinks fast ,then off.

(press remote button, switch on;press again,switch off)

*Latched mode:Press the "pairing button" 3 times fast,red led light on,then press the transmitter

button A, red light blinks fast ;then press button B,red light blinks fast,then off.

(press remote button A, switch on;press button B,switch off)

*10 seconds countdown: Press the "pairing button" 4 times fast,red led light on,then press the

transmitter button, red light blinks fast ,then off.

(press remote button, switch on, after 10 seconds it will be off)

*30 seconds countdown: Press the "pairing button" 5 times fast,red led light on,then press the

transmitter button, red light blinks fast ,then off.

(press remote button, switch on, after 30 seconds it will be off)

*90 seconds countdown: Press the "pairing button" 6 times fast,red led light on,then press the

transmitter button, red light blinks fast ,then off.

(press remote button, switch on, after 90 seconds it will be off)

*120 seconds countdown: Press the "pairing button" 7 times fast,red led light on,then press the

transmitter button, red light blinks fast ,then off.

(press remote button, switch on, after 120 seconds it will be off)

PAGE 1
KG1201-A Operating instructions If you want to control your water pump and dust collector by KG1201-A,you need to pair the switch to your transmitter first. 1. How to clean code: press the paring button 8 times , light flashes,cleaning code completely 2.How to set working mode: Powen on the switch first *Momentary mode:Press the "pairing button" one time fast,red led light on,then press the transmitter button, red LED blinks fast ,then off.
PAGE 2
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.