Parts List

ManualsBrandsDonaldson ManualsElectronicsDigital Universal Transmitter

System overview

The Digital Universal transmitter is a wireless transmitter designed to be connected to the TE oil

condition sensor. The sensor data is transmitted wirelessly to a Donaldson receiver connected to a

vehicle CAN bus, Telematics device, or datalogger.

Contents

1. Part numbers

2. Tools

3. Oil condition sensor install

4. Harness install

Kit parts list

Tools

• side cutters (trim zip ties)

• Heat source (heat shrink)

• Hex 6mm (remove pug from oil adapter)

• Hex 1/8” (set screw)

• #2 Phillips Screwdriver (Ground terminal)

• Wire strippers/crimpers

Materials

• Medium-Strength Loctite (set screw)

• Zip ties (secure harness)

Part number

Item description

X220138

Universal Transmitter, digital

P290066

Harness, UT digital

*New

Oil condition sensor

*New

Oil filter adapter

Zip ties

Summary of content (8 pages)

PAGE 1
System overview The Digital Universal transmitter is a wireless transmitter designed to be connected to the TE oil condition sensor. The sensor data is transmitted wirelessly to a Donaldson receiver connected to a vehicle CAN bus, Telematics device, or datalogger. Contents 1. Part numbers 2. Tools 3. Oil condition sensor install 4.
PAGE 2
Before beginning the install be sure to have the necessary equipment to change out an oil filter. An oil sample may have been requested, collect a sample after the completion of the install. Oil condition sensor install 1. Locate and remove the oil filter. a. follow manufacturer’s instructions on oil filter removal. 2. Installing the 5 plugs to the spacer. a. Install the spacer in the filter location. b. Choose one of the ports free of obstruction for sensor install. c.
PAGE 3
4. Install the oil condition sensor into the spacer block. 5. Find a location to mount the Universal Transmitter within the harness reach. Note: It is best to have the Universal Transmitter mounted against a flat surface. The connector should not be pointed up as that may allow water to follow the wires to the connector. It is best to have water follow the wires away from the connector. a. The center of the box is designed to retain a strap.
PAGE 4
b. The holes at the four corners can be used for tie strap or bolts. 6. Attached the harness to the universal transmitter. 7. Press the red tab into the locked position.
PAGE 5
PAGE 6
8. Attach the connector to the sensor. a. Lock the connector by pressing on the red tab of the connector. 9. Secure the wires to the connector by creating a loop and using a zip tie. The loop should be 3 to 6 inches. a. Secure the wire lead to the connector with a zip tie. 10. Attach the ring terminal on the harness to the spacer block. 11. Install the oil filter.
PAGE 7
PAGE 8
Harness install 1. Determine the locations from which to get switched (key) power and ground. 2. Power should be connected to a 5A fuse. a. If an existing 5A circuit cannot be found, simply add a 5A inline fuse to the harness. 3. Route the power and ground, from any installed universal transmitter harness, to the intended power source. a. Keep harness away from hot locations such as around the turbo charger. b. The harness should have retention about every 12". c.