Installation Instructions

ManualsBrandsDonaldson ManualsElectronicsAnalog Universal Transmitter

5/07/2020

System overview

The Analog Universal transmitter is used to transfer sensor data wirelessly. The wireless signal is then

picked up by a Donaldson receiver connected to a vehicle CAN bus, Telematics device, or datalogger.

Since only power and ground are required, aftermarket installation becomes easier.

Contents

1. Part numbers

2. Tools

3. Fuel sensor install

4. Harness install

Part number

Item description

X220137

Universal Transmitter, analog

P290067

Harness, Analog

*New

Heavy duty sensors, vacuum

*New

T-Fitting, M22x1.5 to ¼ NPT

*fittings needs may vary with

application.

Tools

• side cutters (trim zip ties)

• Heat source (heat shrink)

• Wrench (tighten fuel fittings)

• Wire strippers/crimpers

Before beginning the installation there are a few things to consider.

• The Universal Transmitter should not be mounted in a metal enclosure, which would prevent

the wireless signal from getting out. Mount in a location with as much free space as possible to

prevent interference with the wireless signal.

• The Universal Transmitter requires switched (key) 12V power. Identify the source before

Summary of content (7 pages)

PAGE 1
5/07/2020 System overview The Analog Universal transmitter is used to transfer sensor data wirelessly. The wireless signal is then picked up by a Donaldson receiver connected to a vehicle CAN bus, Telematics device, or datalogger. Since only power and ground are required, aftermarket installation becomes easier. Contents 1. Part numbers 2. Tools 3. Fuel sensor install 4.
PAGE 2
5/07/2020 beginning the install. Fuel pressure install 1. Locate primary (chassis mounted) fuel filter on the vehicle. 2. Find a nearby location to mount Universal transmitter. a. The Universal transmitter is designed to be strapped to a flat surface. b. It is preferable that the electrical connector does not point up. Water can flow down the wire and pool on the seal increasing the risk of water damage. 3. Remove the fuel lines by unthreading them from the filter head. a.
PAGE 3
5/07/2020 6. Install the adapter to the Tee fitting. 7. Install the fuel sensors into the adapter. 8. Prime the fuel system. a. Check for leaks. 9. Find a location to mount the Universal Transmitter less than 5’ from the sensor. a. Do not place in a metal enclosure as it may block the wireless signal. b. It is best to have the Universal Transmitter mounted against a flat surface. The connector should not be pointed up as that may allow water to follow the wires to the connector.
PAGE 4
5/07/2020 c. The center of the box is designed to retain a strap.
PAGE 5
/07/2020 d. The holes at the four corners can be used for tie strap or bolts. 10. Attached the harness to the universal transmitter.
PAGE 6
5/07/2020 11. Press in the red tab to lock the connector. 12. Attach the harness connectors to the fuel sensors. 13. Press the red tab to lock the connector.
PAGE 7
5/07/2020 14. Secure the wires to the connector by creating a loop and using a zip tie. The loop should be 3 to 6 inches of wire. Note: making the loop too short will put tension on the seal allowing water intrusion. Harness install 1. Determine the locations from which to get switched (key) 12V power and ground. 2. Power should be connected to a 5A fuse. a. If an existing 5A circuit cannot be found, simply add a 5A inline fuse to the harness. 3.