Quick Start Guide

SOL8SDR-C Quick Start Guide

Revision 1.0

Page 1

Item

Connection

34-way header

1. Connect D1804 breakout PCB.

2. Connect J4 (ETHERNET) to a PC or network Ethernet port via CA2856

and D918.

3. Connect J2 (PWR) to 12V power via CA3043.

SMP 50 ohm jack

RF-A COFDM antenna.

SMP 50 ohm jack

RF-B COFDM antenna.

MCX jack

SDI-1 video input.

MCX jack

SDI-2 video input.

CAUTION: The SOL8SDR-C will need consideration for heatsinking or fan cooling as part of the installation.

PAGE 1
SOL8SDR-C Quick Start Guide No Item Connection 1 34-way header 1. Connect D1804 breakout PCB. 2. Connect J4 (ETHERNET) to a PC or network Ethernet port via CA2856 and D918. 3. Connect J2 (PWR) to 12V power via CA3043. 2 SMP 50 ohm jack RF-A COFDM antenna. 3 SMP 50 ohm jack RF-B COFDM antenna. 4 MCX jack SDI-1 video input. 5 MCX jack SDI-2 video input. CAUTION: The SOL8SDR-C will need consideration for heatsinking or fan cooling as part of the installation. Revision 1.
PAGE 2
SOL8SDR-C Quick Start Guide The SOL8SDR-C IP address can be established using DTC’s Node Finder application. If DHCP settings need to be disabled and a fixed address applied, right click on the device to reconfigure. Double click the device on Node Finder to open web browser communications. On authentication, leave the Username blank and enter the Password as Eastwood. Go to the Configuration>Preset>Encoder tab and set the Video Source and Format to match the attached camera.