iQ PLUS EXPANDABLE TO 2-DOG SYSTEM Owner’s Manual Please read this manual thoroughly before operating the iQ PLUS training e-collar.
IMPORTANT SAFETY AND PRODUCT INFORMATION WARNING Please read all safety and product information below before using your Dogtra product. Failure to follow these safety instructions could result in injury to you, your dog and others, or it could result in damage to your Dogtra product or other property. PRODUCT SAFETY Training Methods Dogtra products may be used with a variety of training methods. However, each dog may have a different reaction to training methods and to Dogtra 2 products.
PRODUCT DAMAGE Electrical Product Your Dogtra product contains electrical components and batteries. Do not use or keep your product near heat or flammable sources. Such use or storage may damage your product and/or cause fire, explosion, injury, or property damage. Medical Device Interference Dogtra products contain electrical and magnetic components that emit low level electromagnetic waves and radio frequencies.
UNAUTHORIZED USE Your Dogtra product should be used only in a humane manner to train and educate your dog. Dogtra products are not intended for use in any other manner nor are they intended for use with other animals or with humans. BATTERY Your Dogtra product contains batteries. Take care when removing and installing batteries as your fingers may get caught. Dispose of batteries as provided by your local regulations.
CONTENTS AT A GLANCE MAIN FEATURES OVERVIEW UNDERSTANDING YOUR TRAINING SYSTEM 1. TURNING THE iQ PLUS ON/OFF 2. TRANSMITTER BUTTON FUNCTION 3. RECEIVER FITTING 4. FINDING THE RIGHT STIMULATION 5. MAXIMIZING THE DISTANCE 6. LED INDICATOR 7. CHARGING THE BATTERY 8.
AT A GLANCE Transmitter Receiver Battery Charger Test Light Splitter Cable Owner’s Manual Optional Accessories Auto Charger: The auto charger for the iQ PLUS has an input of 12-volts to 24-volts and has an output of 5-volts 1000mAh. European Charger: designed for use with 220V AC electrical outlets. To purchase optional accessories, please visit www.dogtra.com or call our customer service at (888) 811-9111.
MAIN FEATURES Expandable to a 2-Dog System N C P 400 yd Nick/Constant Stimulation & Pager Vibration 400-Yard Range Lev.
OVERVIEW Antenna 1st Dog/2nd Dog Toggle Switch Rheostat Dial Nick Constant LED Indicator Light Pager Battery Charging Receptacle & Rubber Plug iQ PLUS Transmitter 8 On/Off Magnetic Red Dot
Contact points Collar Strap Contact Points Battery Charging Receptacle & Rubber Plug On/Off Magnetic Red Dot LED Indicator Light iQ PLUS Receiver 9
UNDERSTANDING YOUR TRAINING SYSTEM 1. TURNING THE iQ PLUS ON/OFF 10 To turn the receiver on, place the red dot on the back of the handheld transmitter to the red dot on the receiver. Hold the two red dots together for a moment until the LED light on the receiver comes on. To turn the receiver off, repeat the same procedure holding the two red dots together momentarily. The LED light will turn red for a brief moment indicating that the receiver is now off.
2. TRANSMITTER BUTTON FUNCTION N - Nick button When the Nick button is pressed, the receiver emits a single rapid pulse of electrical stimulation. C - Constant button Pressing the Constant button gives continuous stimulation as long as the button is pressed, for up to 12 seconds. If the button is not released after 12 seconds, the stimulation will automatically turn off as a safety feature.
1st Dog 2nd Dog 1st Dog/2nd Dog Toggle Switch The 1st Dog/2nd Dog Toggle Switch is on the left of the Rheostat Dial. I - 1st Dog Slide the switch to the left underneath “I” and press any of the buttons to operate the first receiver. II - 2nd Dog Slide the switch to the right underneath “II” and press any of the buttons to operate the second receiver.
3. RECEIVER FITTING Proper Fit The receiver should be fitted so that the medical grade stainless steel contact points press firmly against the dog’s skin. You should be able to fit two fingers underneath the collar strap. The best location is on either side of the dog’s windpipe. Improper Fit A loose fit can allow the receiver to move around on the dog’s neck. When this happens, the contact points may rub against the skin and cause irritation.
4. FINDING THE RIGHT STIMULATION Attention! Leaving the receiver in the same location on the dog’s neck for an extended period of time can cause skin irritation due to the sensitivity from the contact points. If the dog is to wear the receiver for long periods, occasionally reposition the receiver every few hours so that the contact points are moved to a different location on the dog’s neck and remove the receiver after 8 hours of usage. Make sure you check for skin irritation each time you use the unit.
lowest level and work your way up. The appropriate level can be found when the dog responds to the stimulation with a mild reaction. Also, as the dog’s attitude changes, especially during times of increased excitement or distraction, you may need to adjust the intensity level. Note: The stimulation intensity can be adjusted even when the stimulation is in use. 5. MAXIMIZING THE DISTANCE Maximum range Typical range Minimum range The iQ PLUS has a 400-yard range.
6. LED INDICATOR The LED indicator flashes every 4 seconds when the receiver is on and ready for use. The LED indicator will light up on both the transmitter and the receiver when the transmitter buttons are pressed. The LED color indicates battery life level. 16 Green = Full charge Amber = Medium charge Red = Needs charge If the unit is used while the LED indicator is red, it may shut down automatically.
7. CHARGING THE BATTERY your Dogtra e-collars. This will prevent any damage that can be incurred from attempting to use a different charger. The Dogtra iQ PLUS uses a lithium polymer battery. Recharge the unit if the indicator light is red, the unit does not turn on, or the system will not stay on when any button is pressed. NOTE 1: Only use Dogtra-approved batteries, chargers, and accessories for NOTE 2: The unit has a partial charge when it leaves the Dogtra facility.
Follow the steps below to charge your system: 1. Open the rubber plugs on the battery charging receptacles and plug in the charging cable. 2. Plug the charger into a 120-volt wall outlet or, if using the auto charger, plug into a cigarette lighter only for lithium polymer batteries (use a 220 volt European charger for Europe). All indicator lights should glow red when properly charging and the unit will automatically shut off during the charging process.
8. CODE SETTING Coding the 1st Dog Position: 1. Set the Rheostat Dial to 0 and place the toggle switch in “I” position. 2. With the receiver turned off, place the red dot on the back of the transmitter to the red dot on the receiver. Hold the two red dots together for about 5 seconds until the green LED blinks rapidly on the receiver. 3. While the green LED is rapidly blinking on the receiver, separate the two devices and press the two top buttons (Nick & Constant) simultaneously on the transmitter.
GENERAL TRAINING TIPS Your dog must know some basic obedience commands before beginning training with the iQ PLUS. A dog learns by first being shown a command, followed by lots of repetition over an extended period. As the dog becomes proficient at these commands, the trainer can introduce distractions and different locations to strengthen them. standard collar is used to "teach" the dog the basic obedience commands (here, heel, sit, and stay). A tug on the leash/ collar is used to reinforce the command.
obedience drills. Apply light stimulation (Nick or Constant) when a command is given; the stimulation can be removed as the dog complies. Through repetition, the dog learns to perform the command. The final step is the avoidance phase in which the dog learns that he can avoid the stimulation altogether by performing your commands. When these training procedures are complete, the e-collar is used as a reminder when the dog does not comply with your commands at home or in the field.
MAINTENANCE Basic Maintenance Make sure the rubber charging cap is securely in place when the receiver is in use. After each training session, carefully inspect the unit for any missing parts or damage to the casing. Damaged or broken casing may affect the waterproof guarantee on the unit. After confirming that there is no damage to the casing, rinse the receiver and clean out any dirt or debris. Storage Maintenance The iQ PLUS should be fully charged before storing for extended periods.
TROUBLESHOOTING GUIDE 1. My dog is not reacting to the system. - Make sure the receiver and transmitter are on. - Make sure the collar strap is tight enough so both contact points are touching the dog’s skin. - The contact points may be too short for your dog’s thick or long coat. You might need to trim down the hair on the dog’s neck, so both contact points are touching the skin. - The intensity level may be too low for your dog.
3. The transmitter has no range or stimulation is less when the dog is farther away. - The antenna(s) may be damaged. To order parts, please contact customer service at (888) 811-9111 or go to www.dogtra.com. - The range indicated on the unit’s box is for flat terrain. Heavy brush, trees, hills, or moisture will affect the range of your unit. For best range, hold the transmitter vertically above your head, and/or try moving to higher ground.
the dirt out with a cotton swab and some rubbing alcohol. If the dog is in saltwater, be sure to rinse the receiver and charging port with clean water. – If the above does not resolve your issues, contact Dogtra customer service at info@dogtra.com or (888) 811-9111. 5. My dog has skin irritation. - This may be due to an improper fit or from wearing the unit too long. If your dog exhibits signs of skin irritation, consult with a veterinarian.
DOGTRA PRODUCT WARRANTY LIMITED WARRANTY For Dogtra Products Purchased from Dogtra Authorized Dealers One-Year Warranty Except as otherwise provided below, Dogtra warrants to the original retail purchaser (“You”) that its Dogtra products shall be free of defects in materials and workmanship for a period of one (1) year from the date of purchase (“Warranty”).
Sole Warranty This Warranty is the only warranty offered by Dogtra for its Dogtra products. Other than said Warranty, Dogtra makes no other representations or warranties whatsoever regarding its products, whether oral or in any product manual, on any packaging, on any website, or in any other written material. No dealer of Dogtra products, nor any employee or agent of Dogtra, is authorized to make any additions, changes, or extensions to the Warranty.
shall remain in full force and effect and shall in no way be affected or invalidated, and the invalid or unenforceable portion shall be modified so as to most nearly achieve the intent of the Warranty. Product Registration Dogtra recommends that customers register their products as soon as possible after purchase. Product registration will facilitate any future warranty service. You may also receive useful information and updates about your existing and future Dogtra products.
FCC Warning This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. This is a sensitive radio device. Any unauthorized changes or modifications to this device that are not expressly approved by Dogtra will void the warranty and may void the user's authority to operate the equipment.
