User's Manual

ManualsBrandsDogtra ManualsElectronicsStarWalk

PairingCharging

Use the USB charging cable to charge the StarWalk from

a USB power source. The StarWalk will flash green when

charging is complete. The StarWalk will flash red when it

needs to be charged and while it is plugged into the

charger.

On: To turn on the StarWalk, hold down the

MultiButton for 3 seconds until the StarLight flashes

in white.

Off: To turn off the StarWalk, hold down the

Multibutton for 3 seconds until the StarLight flashes

in red.

On/Off

iQ StarWalk 1 iQ StarWalk 2 iQ StarWalk 3 iQ StarWalk 4 iQ StarWalk 5

1. Turn the StarWalk off.

2. Log into the StarWalk smart phone application

and complete your dog profile.

3. Click Device > Pairing the StarWalk > Search, in the app.

4. Hold down the MultiButton on the StarWalk until

you see the completed message on the app.

2) Search + Push

3) Pairing OK

3) Retry

1) StarWalk Off

Parts and Accessories

StarLight

StepLight MultiButton

USB Charging

Port

OPERATION

CONTENTS

USB Charging

Cable

Attachment

Belt

Attachment

Bracket

Attention

Charge the StarWalk fully before your first use.

A full charge takes about 2 hours.

The StarWalk will need to be re-synchronized after

charging from a state of full discharge.

The connection range between the StarWalk and

your smart phone is 10 meters.

The StarWalk is waterproof up to IPX7, but for maximum

reliability, dry thoroughly after contact with water or

if fully submerged. Close the USB charging port cover

securely over the charging port while the StarWalk is

in use.

Rinse the StarWalk lightly with fresh water if the

device comes in contact with saltwater.

To pair the StarWalk with your smart phone,

start with the StarWalk device turned off.

Summary of content (2 pages)

PAGE 1
Parts and Accessories Attention OPERATION Charge the StarWalk fully before your first use. A full charge takes about 2 hours. StepLight MultiButton Charging Pairing The StarWalk will need to be re-synchronized after charging from a state of full discharge. 3) Pairing OK The connection range between the StarWalk and your smart phone is 10 meters.
PAGE 2
Using the MultiButton Attaching the Belt Bracket 1. Align the guideline on the belt as shown and insert it into the attachment bracket. Goal Progress Press the MultiButton once when the StarWalk is turned on to check your dog’s goal progress. The StepLights will flash for 1 minute with each StepLight representing 20% of your dog’s daily goal. Night Walk Press the MultiButton again while in Goal Progress to turn on the Night Walk feature.