Instruction Manual

PARTS INCLUDED
• Device holder
• Wireless charger
•
•
Vent mount
Suction mount
COMPONENT IDENTIFICATION
1. Clip
2. Charging coil
3. Charger
4. Bottom clip
5. Tightning knob
6. Ball joint
7. Air vent clip
8. Charging LED
9. Micro USB port
INSTALLATION
Place the screw cap (threads fac -
ing up) over the mount’s ball joint.
Snap the device holder onto the mount’s
joint, you will hear a “snap” when it is prop -
erly connected.
Place the holder onto the air vent or wind -
shield as desired.
Adjust as necessary.
Air vent clip and suction mount can be adjusted to the optimum angle
for your vehicle.
Connect to charge
Align the device holder over the
mount's ball joint.
Adjust the bottom clip to ensure the wireless
charging pad is in the correct place on your
device.
WD-234A
WIRELESS CAR CHARGER
Instruction Manual
Please
Recycle
UNDERSTANDING THE LED LIGHTS
Green LED ON–Charging
Green LED OFF–Standby
Blinking LED–Foreign object in charger
Blinking LED–Overheat warning
Blinking LED–Voltage too high
WARNING
DO NOT put metal objects on charger
Keep charger dry
DO NOT use if damaged
DO NOT charge with a damaged, broken or exploded battery
DO NOT use or under 0ºC or over 30ºC
DO NOT store in frigid temperatures to avoid moisture build up inside
the charger
DO NOT open or repair
DO NOT throw, beat or shake to avoid internal damage
SPECIFICATIONS
Charging modes: 5W/7.5W/10W
Input: 5V/2A; 9V/1.67A
Charging distance: <0.2" (5mm)
� 75%
Size: 4.33x3.8x2.13in
Qualcomm Quick Charge is a product of Qualcomm Technologies, Inc. , and/or its
subsidiaries.
Qualcomm is a trademark of Qualcomm Incorporated, registered in the United
States and other countries. Quick Charge is a trademark of Qualcomm Incorpo -
rated.
215.9mm
297mm
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
RF Exposure Warning Statements:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This equipment shall be installed and operated with minimum distance 20cm between the radiator & body.
FCC ID : ZBCWD234A